DTM System FLEX4G Betriebsanleitung Seite 21

4. RECEIVER MANAGEMENT
4.1. Receiver configuration
The receiver configuration is done via the CloudFlex server. You must log in to your user account on the
www.cloudflex.dtm.pl website and add the receiver to the list of authorized devices. The receiver addition
procedure will require the user to enter the receiver ID number and MAC address.
4.2. Retrieving the receiver's ID and MAC
Press the SW button on the receiver board briefly. The ERR LED will light up. Within 5 minutes of the ERR LED
lighting up, send an SMS to the receiver number with the following content: getid
The receiver will respond by sending the receiver's ID and MAC.
You must ensure there are funds on the receiver's SIM card to be able to send an SMS.
4.3. Adding remote controls without logging in to the CloudFlex website
The receiver configuration, including adding remote controls to the memory, is done via the
www.cloudflex.dtm.pl service.
There are also ways to add remote controls to the receiver without having to log in to the CloudFlex service.
Remotely adding a remote control that is within the radio range of the receiver
EN
Press and hold any button on the previously assigned remote control for approx. 15 seconds, within
no more than 3 seconds of releasing the remote control button, press and hold any button on the
remote control that is to be assigned for approx. 15 seconds.
15s
15s
max.3s
previously remote
1 2
added remote to be added
Fig.3 Remote control assignment 15s/15s.