Fluval PLANT 4.0 LED Bedienungsanleitung Seite 2

IMPORTANT SAFETY INSTRUCTIONS
EN
WARNING – To guard against injury, basic safety precautions should be observed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
and all the important notices on the appliance before using. Failure to do so may result in loss of fish life and/
or damage to this appliance.
2. DANGER – To avoid possible electric shock, special care should be taken since water is employed in the
use of aquarium equipment. For each of the following situations, do not attempt repairs yourself; return the
appliance to an authorized service facility for service or discard the appliance.
A. If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power source.
B. Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not
intended to be wet. If the appliance or any part of it falls into the water DO NOT reach for it. First unplug
the unit before retrieving.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or it is dropped or
damaged in any manner. The power cord of this appliance cannot be replaced; if the cord is damaged, the
appliance should be discarded. Never cut the cord.
D. To avoid the possibility of the appliance plug or receptacle getting wet, position the appliance
to one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or
plug. A "drip loop" (see illustration) should be arranged by the user for the cord connecting
appliance to a receptacle. "The drip loop" is that part of the cord below the level of the
receptacle or the connector if an extension cord is used, to prevent water travelling along the
cord and coming in contact with the receptacle. If the plug or receptacle does get wet, DO NOT
unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the appliance.
Then unplug and examine for presence of water in receptacle.
3. This appliance is not intended for use by persons (including children) with significantly impaired physical
or mental capabilities, unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety. Children should always be supervised to ensure that they
do not play with the appliance.
4. To avoid injury, do not touch moving parts or hot parts.
5. CAUTION - Always unplug or disconnect all appliances in the aquarium from electricity supply before placing
hands in water, before putting on or taking off parts and while the equipment is being installed, maintained
or handled. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect. Always unplug an
appliance from an outlet when not in use.
6. Do not install or store the appliance where it will be exposed to weather or temperatures below freezing.
FOR INDOOR HOUSEHOLD USE ONLY. DO NOT IMMERSE.
7. Make sure the appliance is mounted correctly and securely positioned on the aquarium before operating
the appliance.
8. If an extension cord is necessary, a cord with proper rating should be used. A cord rated for less amperes or
watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be
tripped over or pulled. The connection should be carried out by a qualified electrical installer.
9. Use only with AC adapter supplied with this product.
10. The socket-outlet shall be installed near the equipment and shall be easily accessible.
11. LED power supply shall not be positioned on or into the cover frame.
12. "Z" attachments: The external flexible cable or cord of this luminaire cannot be replaced; if cord is damaged
the luminaire shall be destroyed.
13. This luminaire can be mounted on any aquarium with glass thickness of between 3 mm and 15 mm.
14. ATTENTION: The light source of this luminaire is not replaceable; when the light source reaches its end of life
the whole luminaire shall be replaced.
15. ATTENTION: Do not stare at the operating light source.
SAVE THESE INSTRUCTIONS
For the complete use and understanding of this product it is recommended that this manual is thoroughly
read and understood. Failure to do so may result in damage to this product.
Bluetooth transmitter power: -20 dBm - +4 dBm
Bluetooth transmitter frequency range: 2.402 GHZ-2.480 GHZ (2.4G ISM band)
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person
is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient
time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.
Scan QR code for FluvalConnect app instructions or visit
www.fluvalaquatics.com/us/fluval-connect-app-manual
INSTALLATION:
1. Ensure all LED fixture components are present and undamaged.
2. Adjust light fixture extendable brackets to match aquarium width. Bracket edges should rest
securely on aquarium frame to ensure proper fit.
3. Connect transformer to light fixture electrical supply and plug into power source.
FCC STATEMENT