Clearaudio concept Bedienungsanleitung Seite 9

User manual / Bedienungsanleitung
5. Special instructions
5.1 Maintenance
• If the conceptturntable
supply.
• Every two years you can lubricate the bearing of the turntable platter with the oil provided.
In this case it is enough to put 1 or 2 drops of the oil into the bearing.
• Please take special caution regarding any damage of the power cord. Any damage should be
repaired only by authorized personal. A damaged power cord must be exchanged immediately!
5.2 Transport
The conceptturntable should only be shipped in its original packaging.
This is a condition of the Clearaudio
steps given for installation and setup in reverse.
Always remove the turntable
tape securing the tonearm and the cartridge stylus protection. Otherwise serious damage can occur.
Please also ensure that you fully retract the turntable feet.
For any transportation
upper surface facing downwards into the packaging.
Pic. 12: Correct packaging of the platter
Clearaudio assumes no liability for any damage that may occur due to incorrect packing.
5.3 Service
Servicing of all Clearaudio
In case of any repair, the Clearaudio
Clearaudio distributor
Made in Germany
is not used for some time, please disconnect the motor from the mains
warranty. If you repackage the turntable,
platter and replace the foam securing the sub-platter as well as the
of the concept turntable,
products should be done by authorized personnel only.
conceptturntable
or dealer.
please ensure that the platter is packed with the
should be send to your nearest authorized
clearaudio
Loving music
please follow all
Page / Seite 9