Product Application Range; Product Precautionary Items - ECOVACS WINBOT W710 Kurzanleitung

EN

2.3 Product Application Range

2.4 Product Precautionar y Items
7
This product is intended for cleaning dust on common home windows.
●
A glass with uneven surface, such as frosted, textured, patterned or leaded is
●
not suitable to be cleaned by the WINBOT.
If there are any coatings or films (tints) on windows or glass, do not use
●
WINBOT as it may damage the coating or tint.
This product can not be used on windows whose frame thickness is less than
●
5mm (0.2 ).
''
WINBOT is intended for home use only. It can NOT be used on huge
●
windows or in complex places, for example, the windows of commercial office
buildings and industrial sites.
Product not designed for use on small windows (less than 60cm (24
●
and less than 45cm (18
The product will not work on wet windows as the tread will not be able to
●
grasp the window and move the unit, instead it will slide down the window.
Should the kitchen window have a film of oil or grease from cooking, the unit
●
may not be able to grasp the window and move the unit, instead it will slide
down the window.
The unit may NOT be used outside while raining, snowing or colder than
●
as it will damage the product and could cause electrical problems.
(40℉)
Because of the electrical nature of the product, the product may NOT be used
●
in areas where flammable material is used or stored.
The product may not be used to clean cracked or broken windows as the
●
suction will do further damage to the window and would also damage the
product.
Please check that cleaning pads are installed on WINBOT before cleaning.
●
If the window is too dirty, we suggest cleaning a small area to place the
●
WINBOT on the window.
WINBOT can NOT be used to clean stains such as painting, glue, etc.
●
WINBOT can NOT be used to clean items such as chewing gum, label, papers,
●
etc which may cause suction failure.
Do NOT place any obstacles on the window or the window sill which would
●
obstruct WINBOT's cleaning path.
Since the cleaning of the window does not take a long period of time, it is
●
recommended you be in the same room the unit is cleaning the window so
when the unit is done, you can attend to the removal of the unit from the
window. This will also allow you, should there still be a dirty spot, to use the
Remote to guide the unit to clean the spot and then return the unit to a
convenient spot for removal from the window.
We recommend that you use the SAFETY ROPE for cleaning the outside of
●
windows as described in the Safety Rope section of this Instruction Manual.
The adapter should be plugged into a receptacle as close to the window as
●
possible. The adapter MUST never be allowed to hang outside the window.
The Supply Wire from the adapter must be free to move as the unit cleans the
●
inside of the window. Should the unit be cleaning the outside of the window,
enough supply cord must be on the outside of the window so as not to restrict
movement of the unit.
When electrical connection fails or WINBOT finishes cleaning, please remove
●
it from the window. Grasping the handle, turn the unit OFF and use the Air
Release Button or hold onto the handle for 30 seconds or more.
Because the vacuum generated on the bottom of the unit is rather strong, do
●
not place close to body or hand as it will suck the skin into the orifice and unit
would have to be turned OFF to remove the unit from the body part.
Please check the cupule on the bottom of the unit before each use to make
●
sure they are not damaged and would prevent good suction to the window.
Please check that cleaning pads are installed on WINBOT before cleaning.
●
) wide).
''
) high
''
℃
5