ECOVACS WINBOT W710 Kurzanleitung Seite 18

EN
8. What if WINBOT encounters frame
obstructions?
Under normal circumstances, WINBOT
will automatically maneuver around the
obstruction and continue its cleaning.
9. Why does the product fail to
completely clean the door or window
glass?
1) The front pad could be dirty from
cleaning the glass and as a result is
leaving a residue on the glass. Stop and
replace the pad with a clean pad. 2) The
rear pad may be dirty or contain some
debris that is leaving marks on the glass.
You should replace the rear pad with a
clean pad. 3) Check that the treads are
clean. They may also contain some
matter that will leave marks on the glass
that the rear pad can not wipe off. The
treads should be checked often for
cleanliness and wiped with a damp cloth.
4) The provided cleaning solution should
be used when cleaning the glass. A dry
cloth will only wipe dust and NOT clean
the glass. 5) WINBOT cannot clean paint,
stains, paper, or glue from the window.
You will have to continue removing these
residues by hand as you have done
previously.
10 . How to completely clean the door or
window glass?
WINBOT cannot clean paint, stains,
paper, or glue from the window. You will
have to continue removing these
residues by hand as you have done
previously.
11 . How to store the product when not in
use?
The product must be cleaned and with the
switch in the OFF position. It needs to be
stored in a dry place away from heat and
strong sun light which can have a
detrimental affect on the unit.
12 . When the product cleans the outside
of the window and the alarm goes off, I
may not be able to hear the alarm.
WINBOT has a feature that will visually
let you know if a problem occurs while
also sounding its alarm. The Indicator
light on the bottom of the unit will flash
red, letting you know there is a problem
17
that requires your attention.
13 . When the product gets into trouble,
such as stopping in a place on the
window or in the corners, what do I
do?
The product may get into trouble when
cleaning the door and window glass. In
such cases, it will try to get out of trouble;
if it fails, your assistance will be needed.
First, press RESET button to restart the
product and the product should start
cleaning again.
.
14 Can WINBOT completely clean the
corners of the window glass?
WINBOT is programmed to clean the
windows as good and efficiently as
possible. There may be some
circumstances that corners may not be
totally cleaned. With the Remote, you
can take control of WINBOT when it has
finished cleaning the window and drive it
to those spots that need to be attended
to. We feel that this will satisfactorily
resolve your problem.
Should you still encounter some
situations that have not been properly
addressed to your satisfaction, we ask
that you contact our Service
Department where a Technician can
properly address your specific
problem or question. Or call our
service number.