Product Restart; Accessories; Safety Pod; Remote Control - ECOVACS WINBOT W710 Kurzanleitung

EN
4.5 Product Restar t

5. Accessories

5.1 Safety Pod

Warning
If WINBOT is used to clean a window above ground level, the Safety Pod MUST be used.
WINBOT must be used in strict accordance with the directions in the Instruction Manual. ECOVACS can not be held
liable or responsible for any damages or injuries caused due to improper use.
1. Make sure that there is enough power cord for the WINBOT to clean the entire window without restricting its movement.
If there is not enough cord, it is not safe to use the WINBOT on that particular window until a WINBOT Extension Cord is
attached.
2. Loop one end of the Safety Rope around the Safety Pod's channel and pull it tight.
3. Loop the other end of the Safety Rope to the power connector on the power cord and tighten.
4. If an Extension Cord is attached, the Safety Rope must be tied to the power connector on the Extension Cord.
Note: Do NOT attach the Safety Rope to the thin part of the cord.
5. Press the Safety Pod suction cup FIRMLY in the lower corner on the opposite side of the glass you are cleaning. Make
sure the Safety Pod suction cup is securely in place.
6. Place WINBOT on the window, close the window if cleaning the outside of the window, and start WINBOT.
7. After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the unit OFF, insert finger into Air
Release Trigger and pull up on it for 20 seconds until suction has diminished.

5.2 Remote Control

Before use of the remote control, please confirm whether the battery has been installed correctly.
The remote control uses two AAA batteries.
●
During installation of the battery, be sure to pay attention to the direction of the positive and negative poles of the
●
battery and the diagram in the Remote Control casing.
If the battery power is low, replace both batteries; never use a new battery with an old battery.
●
If the remote control is not used for a long time, please remove the batteries so they will not damage the Remote
●
Control.
Do not place the remote control in the Sun or next to a heat source as this can damage the Remote Control.
●
Should liquid be spilled on the Remote Control, remove the batteries immediately and shake till as much of the
●
liquid is out of the Remote Control. Allow to dry for 24 hours before replacing the batteries. Try to use the Remote
with the unit on the window while the unit is within easy reach to see that it works. If the Remote does NOT work,
do not use the unit until the Remote has been replaced.
While replacing the battery, should a foreign object be dropped into the battery area, please remove immediately.
●
IF the object is left in the battery area, possible shorting of the batteries could happen and render the Remote
Control useless.
Please follow the local environmental regulations for the disposal of the discarded batteries.
●
11
When the product cycles a place repeatedly during the operation, or stops
working, sending a warning prompt and the red indicator light flashing,
grasp the unit by the handle and turn the switch to the OFF position. Then,
turn the unit back ON and press the Pause/Start button on the unit to
continue the cleaning process.