Day-To-Day Storage; Maintenance; Cleaning The Unit; Cleaning And Replacing Cleaning Cloth - ECOVACS WINBOT W710 Kurzanleitung

1
2
4
5 3
6
7
OFF ON

6. Day-to-day Storage

7. Product Maintenance

7.1 Cleaning the Unit

7.2 Cleaning and Replacing Cleaning Cloth

The Remote Control has a series of functions to become familiar with. The
Remote Control is very easy to use.
1. RESET button - Should the WINBOT stop working in any way, the RESET button
can be pressed to restart the product and/or restore it to the factory defaults.
2. Start / Pause button - Starts and/or Stops the product.
3.4.5.6 Arrows - When pressed each arrow indicates the direction the unit will
move, remembering that the UP arrow corresponds to the front of the WINBOT.
7. Pairing button - This button pairs the Remote Control with WINBOT.
Notice - The Remote Control is already paired with WINBOT when it arrives from
the factory. If you need to replace the Remote Control, please use the Pairing
button to pair the Remote Control with WINBOT.
Pairing method:
Plug WINBOT in and place WINBOT's switch to the CHARGE position. Hold the Pairing
button on the Remote Control unit. Then press the Start/Pause button on WINBOT
until WINBOT beeps (about 3 seconds). Pairing action is complete when WINBOT
beeps.
The Remote Control will work best when within 2m (6.5 ' ) of the unit. Maximum
distance between Remote Control and Winnbot is 12m (39.4 ') .
Storage of the unit must be away from high temperatures as the plastic
●
and electronic components can be affected.
Do not store the unit close to liquids where the liquid might be spilled
●
onto the unit and get inside and damage the unit.
Pay attention to the maintenance requirements of the unit as spelled out
●
in that section of the Instruction Manual.
The Unit must be in the OFF position and unplugged from the electrical source.
The Unit may NOT be cleaned with any volatile liquid such as solvent, gas, etc.
or a detergent containing acidic or pine sole additives as they will negatively
affect the plastic.
After each cleaning or should the Pad get really dirty before finishing the
cleaning of the window, the Pad can be rinsed in clear warm water. Be careful
of detergent you might use to wash the pad as you do not want to leave a soapy
film on the pad that will not allow the Pad to properly clean the window. After
thoroughly dried (generally dry for 24 hours), re-install the pad on the unit.
Live Smart. Enjoy Life.
EN
12