Use Of Product - ECOVACS WINBOT W710 Kurzanleitung

EN

4. Use of product

Warning
If WINBOT is used to clean a window above ground level, the Safety Pod MUST be used.
WINBOT must be used in strict accordance with the directions in the Instruction Manual. ECOVACS can not be held
liable or responsible for any damages or injuries caused due to improper use.
Note: Before operation of the unit, you must carefully read the content of "Safety Introductions" before using the
product. Any operation inconsistent with the contents of Instruction Manual may cause damage to the product or
cause personal injury.
4.1 Placement of WINBOT
9
Make sure that there is enough power cord for the WINBOT to clean the
●
entire window without restricting its movement. If there is not enough cord,
it is not safe to use the WINBOT on that particular window until a WINBOT
Extension Cord is attached.
Loop one end of the Safety Rope around the Safety Pod's channel and pull
●
it tight.
Loop the other end of the Safety Rope to the power connector on the power
●
cord and tighten.
If an Extension Cord is attached, the Safety Rope must be tied to the power
●
connector on the Extension Cord.
Note: Do NOT attach the Safety Rope to the thin part of the cord.
Press the Safety Pod suction cup FIRMLY in the lower corner on the
●
opposite side of the glass you are cleaning. Make sure the Safety Pod
suction cup is securely in place.
Place WINBOT on the window, close the window if cleaning the outside of
●
the window, and start WINBOT.
Make sure the button on the bottom of the WINBOT is turned ON.
●
Plugging the Adapter into your receptacle and push the power button to start
●
WINBOT.
Spray the front Pad with the provided Window Cleaning Solution lightly. After
●
having cleaned your windows a number of times, you will begin to know how
damp the Pad should be to clean your windows. If you get the Pad too Wet, it
may not allow the treads to properly drive the unit on the window. Do NOT
spray the back pad as this Pad is for wiping the window after the treads.
With the unit placed horizontally on the window and about 10cm (4'') from the
●
corners of the lower window, move the switch to the ON position and only let
go once the unit has securely attached itself to the window being indicated by
the Indicator Light flashing BLUE in color. At this point, you should remove
your hand from the unit.When Indicator Light do NOT light, it means the
suction power in too small. Please check or replace the cupule. When
Indicator Light flashes red, please adjust the height of placement and restart
the product.
With the Safety Rope attached to the inside of the window, close the window
●
without damaging the outer skin of the Supply Cord. Make sure there is
enough cord between the Safety Rope and the WINBOT for the unit to clean
the entire window without restricting its movement.