Resus Risycor CX Betriebsanleitung Seite 33

4. Fit the probe into the threaded connector to the correct depth, as
marked.
CAUTION! Do not use any sealing material (flax, Loctite, ...) The
O-rings of the probe provide sufficient sealing. The thread is used
to ensure the proper installation depth for the probe. The thread
must not be damaged in any way. Do not cause any scratches!
5. Click the logger firmly onto the probe (only one position is
possible).
CAUTION! Check that the logger is pushed over the probe to a
sufficient depth (the O-ring on the probe must be completely
covered by the collar of the logger). Never use the logger to
tighten the probe, however.
EN
33