Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Control Board
The Control Board offers several features: you can simply set the starting address or run the pre-
programmed program.
The main menu is accessed by pressing Menu until the display is lit. Browse through the menu by pressing
Menu. Press Enter in order to select the desired menu. You can change the selection by pressing Up or
Down. Press Enter in order to confirm. You can leave every mode by pressing Menu. The functions provided
are described in the following sections.
Menu
Addr
Chnd
Slnd
Shnd
Auto
Soun
Sens
PInt
TInt
Led
Disp
Test
Rset
DMX-controlled operation
You can control the fixtures individually via your DMX-controller.
The device has two different DMX channel modes.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED SDR-8 will respond to the controller.
If you set, for example, the address in the 14 channel mode to channel 15, the device will use the channel 15
to 28 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED SDR-8 correctly
and independently from any other fixture on the DMX-chain. If several LED SDR-8 are addressed similarly,
they will work synchronically.
Sub menu
A001-A512
DMX address setting
10Ch
Setting DMX channel mode
14Ch
Mast
Master setting
SL1
Slave 1 setting
SL2
Slave 2 setting (opposite)
SH0-SH15
Internal programs
Off
Automatic internal program
On
Off
Sound-controlled internal program
On
000-100
Microphone sensitivity (increasing)
No
Reverse movement TILT1
Yes
No
Reverse movement TILT2
Yes
Display turn off when the buttons are inactive
ON
ON - Display always on.
OFF
OFF - Shuts off the display after 40 seconds
dISP
Display reverse 180 degree
Function test
Reset
Function
27/32
00103432, Version 1.0
Werbung
Inhaltsverzeichnis
