DETERGENTS
Use detergents designed for power
cleaners.
Hardware stores or home centers also
cleaning projects. The cleaning solution
should be the consistency of water in order
to prevent clogging your detergent bottle
and nozzle, this system applies detergent
under low pressure. The cleaning power of
the detergents is enhanced when applied
with low pressure and enough time is
given to break down dirt and grime. The
combination of low pressure and chemical
than scrubbing if applied properly. Always
spray detergent on a dry surface. Do
not pre-soak area. Wetting the surface
cleaning ability. Do not allow detergent to
dry on surface. On vertical surfaces being
cleaned, apply detergent to lower surfaces
and work your way up to prevent detergent
from causing streaks in the dirt and grime.
Rinse detergent by pressure washing from
bottom up for same reason.
If a stain is particularly tough, it may be
necessary to reapply the detergent and
use a bristled brush to scrub the stain.
Subsequent power washing after brushing
should successfully complete your cleaning
job.
CLEANING NOZZLES
A clogged or partially clogged nozzle can
pressure coming out of the nozzle and/or
cause the unit to pulsate while spraying.
Relieve any pressure trapped in the hose by
squeezing the trigger 2 - 3 times, then
lock the gun by pressing the button to lock
position.
CARE AND MAINTENANCE
Using the nozzle tip cleaner provided (or an
unfolded paper clip), insert the wire into the
nozzle hole and move back and forth until
debris is dislodged.
garden hose and highest pressure available
(either standard water nozzle or use your
thumb over the nozzle to create water
21