1.BATTERY CHARGING
The battery is supplied partially charged.
To ensure full capacity of the battery,
completely charge the battery in the battery
charger before
A fully discharged battery pack will charge
in 50 minutes for DB1850 in a surrounding
temperature between 32° F (0° C) and 104°
F (40° C).
1. Charge the Lithium-Ion battery pack with
the correct charger.
2. Connect the charger to a power supply.
3. Align the raised ribs of the battery pack
with the slot in the charger.
4. Slide the battery pack onto the charger.
5. The charger will communicate with the
battery pack to evaluate the condition of
the battery pack.
with compressed dry air. Always wear
safety goggles when cleaning tools with
compressed air.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean clothes to remove dirt, dust, oil,
grease, etc.
BEFORE EACH USE
switch and the accessories for damage.
2. Check for damaged, missing, or worn
parts.
20
OPERATION
6. The POWER BAR LED lights will cycle
from right to left during charging. This is
part of the normal charging operation.
7. After charging is complete, the green
LED on the charger will come on and the
POWER BAR LED lights will go displayed
when the POWER BAR button is pressed
while the battery pack is on the charger.
8. The battery pack will fully charge if left on
the charger, but it will not overcharge.
NOTE: For your convenience, the charger
can operate with most generators and
inverters rated at 300 watts or higher.
OPERATION
3. Check for loose screws, misalignment
or binding of moving parts, or any other
4. If abnormal vibration or noise occurs,
problem corrected before further use.
5. Detach the battery from the Cordless
Tool before cleaning or performing any
maintenance. Using compressed air may
Always wear safety goggles when cleaning
tools using compressed air.
All of the bearings in this tool are lubricated
lubricant for the life of the unit under normal
conditions. Therefore, no further lubrication is
required.
LUBRICATION