simu T5S AUTO Originalanleitung Seite 6

T5S AUTO / T5S AUTO+ / T5S AUTO+SHORT
SIMU S.A.S. au capital de 5 000 000 € - Zone Industrielle des Giranaux - 70100 ARC-LÈS-GRAY - FRANCE - RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
These instructions apply to all T5S AUTO/T5S AUTO+/T5S AUTO+SHORT drives in all torque/speed.
Field of application: T5S AUTO/T5S AUTO+/T5S AUTO+SHORT drive are designed to drive all types of
roller shutters equipped with stop blocks and rigid links. The installer, who must be a motorisation and home
automation professional, must ensure that the drive product is installed in accordance with the standards in
force in the country in which it is installed such as EN 13659 relating to roller shutters.
Liability: Before installing and using the drive, please read operating and installation guide carefully.
Please read these instructions carefully before installing and using the drive. In addition to following the
instructions given in this guide, the instructions detailed in the attached Safety instructions document must
also be observed. The drive must be installed by a motorisation and home automation professional, according to
instructions from SIMU and the regulations applicable in the country in which it is commissioned. It is prohibited
to use the drive outside the field of application described above. Such use, and any failure to comply with the
instructions given in this guide and in the attached Safety instructions document, absolves SIMU of any
liability and invalidates the warranty. The installer must inform its customers of the operating and maintenance
conditions for the drive and must provide them with the instructions for use and maintenance, and the attached
Safety instructions document, after installing the drive. Any After-Sales Service operation on the drive must
be performed by a motorisation and home automation professional. If in doubt when installing the drive, or to
obtain additional information, contact a SIMU adviser or go to the website www.simu.com.
1 INSTALLATION
Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC 60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
- The cable for the motor can be removed. If it is damaged, replace by the same. The cable may only be
connected to the motor by qualified personnel. The connector is to be assembled without damaging the
contacts. The continuity of the earth connection must be ensured.
Recommendations: The motor torque must be selected according to the shutter's characteristics. Do not
oversize the operator. To receive information regarding the compatibility of the motor and the roller shutter
or/and accessories, contact the roller shutter manufacturer or SIMU.
Drilling the tube:
T5S AUTO
T5S AUTO+
T5S AUTO+SHORT
Assembly:
T5S AUTO/T5S AUTO+/T5S AUTO+SHORT
V.A.S
EASYLINK
OCTOEASY
MANDATORY
EN
2/3
(230V~50HZ)
Ø62 48
21
45 24
120
3
4
4 x ØB / 90°
L1
IP44
4
L2
2
1
5157762A
EN- ORIGINAL INSTRUCTIONS
Ø min.
25/17 • 35/17
06/17 • 10/17
47
15/17
20/17
06/17 47
T5S AUTO+SHORT
Ø4,8 x 10
STEEL
Ø5 x 10
3
4
i
-20°C / +60°C
A ØB L1 L2
670 691
657
496 517
483
5
516 537
503
596 617
583
349 5 362 383
2
1
5