ECOMAT 2000 Select Gebrauchsanweisung Seite 17

EN
Important:
• The fi lter mat on the rear of the appliance must be cleaned regularly by wiping it by hand or by
squeezing it out briefl y in a water bath.
• If the fi lter mat has a grey discolouration due to accumulated dust it must be cleaned.
• The heating output reduces by more than 50% when the fi lter is moderately to extremely dust
laden!
• Only genuine dust fi lters may be used. Otherwise the heating power may reduce.
Cleaning the appliance
Disconnect the appliance from the socket before you clean it. Do not use liquid cleaners or sprays. Clean
the fi lter with a damp cloth.
To clean or replace the fi lter mat, simply pull off the cover.
Technical operating data
Electrical connection
• Voltage:
• Amperes:
• Power:
• Cable connection:
• Conformity:
Important information for operation with...
... electricity generator
• Minimum power: at least 800 watts
... voltage transformer (inverter)
• Voltage transformer type:
• Power:
• Voltage:
Version for high seas (optional)
Waterproof caps are mounted on the selector switches to prevent water from entering the switch and
causing damage when operating with wet/damp hands.
Make sure that the required switching operation has been carried out by checking that the switch is
properly engaged.
With this optional version, the PCB has a silicone coating which prevents oxidation in salty or extremely
moist air.
230 VAC 50/60 Hz
2 / 4 / 6–10 = fuse protection
450 – 750 – 1500/1800 W (without fi lter)
CH socket type 12 (with earthing pin)
Grounding-type plug with earth contact /
only connect when earthed.
The appliance is lead and mercury free and complies
with the RoHS guidelines.
Sine wave !!!
At least 800 W with 450 W power
220–230 VAC 50/60 Hz.
ECOMAT2000 | 17