Whirlpool K 140 GS/I Installation Und Gebrauch Seite 21

Cooker routine maintenance and cleaning
Before each operation, disconnect the cooker from
the electricity.To assure the long life of the cooker, it must
be thoroughly cleaned frequently, keeping in mind that:
· the enamelled parts and the self-cleaning panels are
washed with warm water without using any abrasive
powders or corrosive substances which could ruin
them;
· the inside of the oven should be cleaned fairly often
while it is still warm using warm water and detergent,
followed by careful rinsing and drying;
· the flame spreaders should be washed frequently with
hot water and detergent taking care to eliminate any
scale;
· Stainless steel may become marked if it comes into
contact with very hard water or harsh detergents
(containing phosphorous) for long periods of time. After
cleaning, it is advisable to rinse thoroughly and dry. It
is also recommended to dry any water drops;
•
On models with glass covers, the covers should be
cleaned with hot water; the use of rough cloths or
abrasives is to be avoided.
N.B: avoid closing the cover while the gas burners
are still warm. Remove any liquid from the lid before
opening it.
Important: periodically check the wear of the gas hose
and substitute it if there are any defects; we recommended
changing it every year.
Replacing the oven lamp
Unplug the oven from the mains;
·
Remove the glass cover of the lamp-holder;
·
Remove the lamp and replace with a lamp resistant to
·
high temperatures (300°C) with the following
characteristics::
- Voltage 230V
- Wattage 25W
- Type E14
Replace the glass cover and reconnect the oven to
·
the mains.
Greasing the taps
The taps may jam in time or they may become difficult to
turn. If so, they must be cleaned internally and the grease
replaced.
N.B: This operation must be carried by a technician
authorised by the manufacturer.
Removing the lid
The cooker lid can be removed to facilitate cleaning. To
remove the lid, first open it completely and pull it
upwards (see figure)
21