Scholtes PP 73 G SF Bedienungsanleitung Seite 14

Before fastening the cooktop in place, position the
GB
seal (supplied) along the perimeter of the countertop,
as shown in the figure 2.
Clamps are provided to fasten the cooktop to
counters measuring from 20 to 40 mm in thickness.
To fasten the cooktop securely, it is recommended
that all the clamps be used.
Fastening Clamps - Assembly Diagram
Clamp Position for
H=30mm top
Clamp Position for
H=20mm top
N.B: Use the clamps contained in the "accessory
kit."
14
Fig. 2
Clamp Position for
H=40mm top
Front
Back
Hobs installation ( Hobs installation ( Hobs installation ( Hobs installation ( Hobs installation (mod. PPF... - PP..SF) ) ) ) )
Before fastening the cooktop in place, position the
seal (supplied) along the perimeter of the countertop,
as shown in the figure 3.
Fig.3
An insulating wooden panel should be fitted beneath
the hob, positioned at a minimum of 20 mm from the
hob underside. This wooden panel must be
removable in order to allow for any maintenance
operations beneath the hob.
Installing flush-fitted hobs (mod. PPF...) Installing flush-fitted hobs (mod. PPF...)
Installing flush-fitted hobs (mod. PPF...) Installing flush-fitted hobs (mod. PPF...) Installing flush-fitted hobs (mod. PPF...)
To slot in the hob flush with the worktop, it is
necessary to lower the area just outside the cut-out
for the hob as illustrated in figure 4.
Installing semi-flush hobs (mod. PP..SF) Installing semi-flush hobs (mod. PP..SF)
Installing semi-flush hobs (mod. PP..SF) Installing semi-flush hobs (mod. PP..SF) Installing semi-flush hobs (mod. PP..SF)
To create the recess necessary for semi-flush hobs, drill
into the top as illustrated in figure 5.
Fig.4 Fig. 5