MA lighting nPC command wing Schnellstartanleitung Seite 34

On / Off Switching
On / Off Switching
Connect / Installation
Connect / Installation
Download grandMA2 onPC -software from MA – Homepage.
Download grandMA2 onPC -software from MA – Homepage.
MA onPC command wing needs software grandMA2 onPC V 2.5.5.0 and higher ( grandMA1 onPC is
MA onPC command wing needs software grandMA2 onPC V 2.5.5.0 and higher ( grandMA1 onPC is
not applicable).
not applicable).
Install the software „grandMA2 onPC" on your Windows – PC or notebook. Minimum requirements
Install the software „grandMA2 onPC" on your Windows – PC or notebook. Minimum requirements
you will find at: www.malighting.com .
you will find at: www.malighting.com .
switch on your PC or notebook and start MA onPC.
switch on your PC or notebook and start MA onPC.
Connect the command wing direct to your PC or notebook via a USB cable (use no hub or switch!).
Connect the command wing direct to your PC or notebook via a USB cable (use no hub or switch!).
Connect your PC or notebook with the other hardware. Such as shown on previous page.
Connect your PC or notebook with the other hardware. Such as shown on previous page.
Connect the power supply. The command wing is equipped with a PSU (90 -240V // 50 – 60Hz).
Connect the power supply. The command wing is equipped with a PSU (120 -230V // 50 – 60Hz).
PAY ATTENTION TO DETAILS ON PAGE 23
PAY ATTENTION TO DETAILS ON PAGE 23
ON
ON
Set the mains switch on the rear side of the command wing to „I".
Set the mains switch on the rear side of the command wing to „I".
Note: Flashing executor buttons indicates, that the position of this fader does not correspond with the
Note: Flashing executor buttons indicates, that the position of this fader does not correspond with the
position of the virtual fader (internally stored fader position) of the onPC. Position of the virtual fader is
position of the virtual fader (internally stored fader position) of the onPC. Position of the virtual fader is
relevant for value output. After first movement of the command wing –fader (the "real" fader), this
relevant for value output. After first movement of the command wing –fader (the "real" fader), this
position is relevant for value output.
position is relevant for value output.
OFF
Set the mains switch on the rear side of the command wing to „O".
OFF
Note:
Set the mains switch on the rear side of the command wing to „O".
Disconnecting the MA onPC command wing from your PC or notebook is always possible – however
Note:
DMX –output is interrupted immediately.
Disconnecting the MA onPC command wing from your PC or notebook is always possible – however
Show is always stored on yourPC or notebook, not on your onPC command wing.
DMX –output is interrupted immediately.
Update only possible with a PC or notebook and grandMA2 onPC.
Show is always stored on yourPC or notebook, not on your onPC command wing.
For longer non use disconnect all cables.
Update only possible with a PC or notebook and grandMA2 onPC.
For longer non use disconnect all cables.
MA onPC
MA onPC
command wing
command wing
Data
Data
Transport
Transport
Safety
Safety
instructions
instructions
Safety and
Safety and
environmet
environmet
Quickstart
Quickstart
Connect
Connect
Quickstart
Quickstart
ON / OFF
ON / OFF
Maintenance
Maintenance
Conformity
Conformity
32
32