Initial Set Up; Charging The Battery - Medion GoPal E3212 Bedienungsanleitung

Initial Set up

The following guides you step by step through the initial Set-up of the navigation system.
Firstly, remove the foil from the display.
I. Charging the Battery
You have the following possibilities to charge the battery of your navigation system:
•
by means of the car adapter or
•
by means of the USB cable
Attention!
It can be necessary to recharge the battery for some time initially before it
is possible to run through the initial installation, according to the state of
charging of the battery installed.
Please pay attention to the following notes when handling the battery:
•
The charging status display flashes orange until the navigation system is charged.
If possible, do not interrupt the charging process before the
battery is fully charged. This may take a few hours. The navigation system
is fully charged if the charging display lights green.
•
You can use the navigation system during the charging process, but the power
supply must not be interrupted during initial set-up.
•
Leave the external power supply connected to the navigation system for around
24 hours, so that the backup battery also charges-up fully.
•
You can leave the external power supply connected, and this is very handy for
continuous operation. However, the mains adapter (optional) also requires power
even when it is not charging up the battery of the navigation system.
•
It can take several minutes until the device is ready to operate again, following the
connection of the external power supply, if the charging state of the battery is
very low.
•
The battery can be charged while the device is switched off completely.
11