Initial Set Up; Charging The Battery - Medion Gopal P 4245 Bedienungsanleitung

Initial Set up

The following is a step by step guide to assist in the initial Set-
up of the navigation system.
Start by removing the protective plastic sheet from the dis-
play.
I. Charging the Battery
The battery of your navigation system can be charged in the
following ways:

Using the supplied car adapter,

using a suitable USB cable or

by using a mains adapter (purchased as an optional ex-
tra).
Attention!
It may be necessary to initially charge the battery for a
considerable period of time prior to commencing and
running through the initial installation, this is depend-
ent on the level of charge held at the time by the inter-
nal battery.
Please observe the following notes:

The charging status display LED will flash orange until the
navigation system is charged. If possible, do not interrupt
the charging process until the
battery is fully charged. This may take a few hours. The
charging status LED will shine constant green if the battery
has a high level of charge. Leave the device charging for 20
further minutes, to ensure the battery is charged-up fully.
Initial Set up 15