Important Information
Pushbutton Mode
With pushbutton mode, the phase of the extension and t
phase of the supply vol
With pushbutton extensi
not be connected with parallel contacts (use pushbutton
with N connection).
When laying lines, ensure that there is sufficient space
between the control and load lines (min. 5 cm).
-
The maximum line length of the pushbutton extension
unit is 100 m.
-
Changing the conductor routing of existing two-way
circuits and intermediate switch circuits is not
necessary.
Interference Suppression
A novel electronic interference suppressor replaces the
former conventional interference suppression choke.
Consequently, this is a "low-noise" dimmer.
tage must be the same.
ons, the lighting glow lamp should
ENG
37
he