Modster Arrows hobby Twin 64mm Mikoyan MiG-29 Bedienungsanleitung Seite 15

Battery installation
1 . Remove the battery hatch
2. Remove the hook and loop tape from the fuselage
Apply the looped surface to the battery.
3. Install the battery into the fuselage-
the preinstalled battery straps.
Note: The weight of each battery may vary due to
different manufacturing
fore or aft to achieve the optimal
Receiver diagram
The cables from the
connected to your receiver
the LEDs can be powered
receiver.
Tuck the wire leads into the recessed
rear of the battery hatch.
Preflight check
Important ESC and model information
1. The ESC included with the model has a safe start. If the motor battery is connected to the ESC and the throttle stick is not in the low
throttle or off position, the motor will not start until the throttle
moved to the low throttle or off position, the motor will emit a series of beeps. Several beeps with the same tune means the ESC has
detected the cells of the battery. The count of the beeps equals the cells of the battery. The motor is now armed and will start when the
throttle is moved
2. The motor and ESC come pre-connected and the motor rotation should be correct. If for any reason the motor is rotating in the wrong
direction, simply reverse two of the three motor wires to change the direction of rotation.
3. The motor has an optional brake setting. The ESC comes with brake switched off and we recommend that the model be flown with
the brake off. However, the brake could be accidentally switched on if the motor battery is connected to the ESC while the throttle stick
is set at full throttle. To switch the brake off, move the throttle stick to full throttle and plug in the motor battery. The motor will beep one
time. Move the throttle stick to low throttle or the off position The motor is ready to run and the brake will be switched off.
4. Battery Selection and Installation. We recommend the 22.2V 3300mAh 35C Li-Po battery. If using another battery, the battery must
be at least a 22.2V 3300mAh 35C battery. Your battery should be approximately the same capacity, dimension and weight as the 22.2V
3300mAh 35C Li-Po battery to fit the fuselage without changing the center of gravity significantly
securing
techniques. Move the battery
center of gravity.
servo connector board
in the order shown.
by any spare channel
cavity towards
it with
Aileron
should be
Elevator
Note that
on the
Throttle
Rudder
the
Spare
Flap
stick is moved to the low throttle or off position.
Receiver
1
Channel-I
— Aile
2
Channel-2
— Elev
3
Channel-3
— Thro
4
Channel-4
— Rudd
5
Channel-5
— Spare
6
Channel-6
_ Flap
Once the throttle stick is