Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Restore factory settings
7
Restore factory settings
The factory settings of your
Homematic IP Access Point – basic
and of the entire installation can be
restored. The operations distinguish as
follows:
• Resetting the Access Point – basic:
Here, only the factory settings of
the Access Point – basic will be
restored. The entire installation will
not be deleted.
• Resetting and deleting the entire
installation:
Here, the entire installation is re-
set. Afterwards, the app has to be
uninstalled and reinstalled. The
factory settings of your single
Homematic IP devices have to be
restored to enable them to be con-
nected again.
7.1
Resetting the Homematic IP
Access Point – basic
To restore the factory settings of the
Homematic IP Access Point – basic,
proceed as follows:
• Disconnect the Access Point –
basic from the power supply.
Therefore, unplug the USB mains
adapter.
• Plug-in the USB mains adapter
again and press and hold down the
system button (A) for 4s, until the
LED (A) will quickly start flashing
orange.
• Release the system button again.
• Press and hold down the system
button again for 4 seconds, until
the LED lights up green. If the LED
lights up red, please try again.
• Release the system button to finish
the procedure.
The device will perform a restart and
Access Point is being reset.
7.2
Resetting and deleting the entire
installation
To reset the factory settings of the en-
tire installation, the procedure descri-
bed above must be performed twice in
succession, within 5 minutes:
• Reset the Access Point – basic as
described above.
• Wait at least 10 seconds until the
LED (A) permanently lights up blue.
• Immediately afterwards, perform
the reset for the second time by
disconnecting the Access Point –
basic from the power supply again
and repeating the previously de-
scribed steps.
After the second restart, your system
will be reset.
8 Maintenance and cleaning
The device does not require you
to carry out any maintenance.
Enlist the help of an expert to
carry out any maintenance or
repairs.
Clean the device using a soft, lint-free
cloth that is clean and dry. You may
dampen the cloth a little with luke-
warm water in order to remove more
stubborn marks. Do not use any de-
tergents containing solvents, as they
could corrode the plastic housing and
label.
21
Werbung
