JUNO JH084C1 Benutzerinformation Seite 17

Make sure that you install the internal glass
panel in the seats correctly.
11.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
Problem
The appliance does
not heat up.
The door gasket is
damaged.
The display shows
"12.00".
A
Cause and reme‐
dy
The fuse is blown.
Make sure that the
fuse is the cause of the
malfunction. If the
problem persists, con‐
tact a qualified electri‐
cian.
Do not use the appli‐
ance. Contact an Au‐
thorised Service Cen‐
tre.
There was a power
cut. Set the time of
day.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Problem
The water leaks out of
the cavity emboss‐
ment.
Unsatisfying cooking
performance of the
function: True Fan
Cooking PLUS .
The lamp does not
work.
Cause and reme‐
dy
There is too much wa‐
ter in the cavity em‐
bossment. Deactivate
the appliance and
make sure it is cold.
Wipe the water with a
cloth or a sponge. Add
the correct amount of
water. Refer to "Daily
use", Setting the func‐
tion: True Fan Cooking
PLUS.
The cavity emboss‐
ment is not filled with
water. Add the correct
amount of water. Refer
to "Daily use", Setting
the function: True Fan
Cooking PLUS.
The lamp is burnt out.
Replace the lamp. Re‐
fer to "Care and clean‐
ing", Replacing the
lamp.
ENGLISH 17