cecotec CONGA 2000 CARPET&SPOT CLEAN COMPACT Bedienungsanleitung Seite 47

5.2 Waste-water tank cleaning. Fig. 4
1. When the waste water reaches the maximum level, stop using the appliance and unplug
it from the mains.
2. Remove the waste-water tank. To do so, slide the waste-water tank release tab and
remove the waste-water tank.
3. Remove the upper cover of the waste-water tank and empty the waste water.
4. Clean the tank, the top cover and the sealing ring.
5. Place the waste-water tank in the main body of the appliance.
Warning
- Do not lean or shake the waste-water tank when transporting or assembling it; otherwise,
waste water will easily leak.
- We recommend you empty the waste water before it exceeds the maximum level on the
tank; if you continue using the tank after the waste water has exceeded the maximum
water level, the float buoy will activate the appliance for automatic water suction stop and
stop suction.
6. TROUBLESHOOTING
Problem
The upholstery
cleaner does not work
properly
Hardly any water
is released by the
appliance
Possible causes
Check that it is correctly connected
to the mains.
The power cable is damaged.
The power switch is in the off
position.
The waste-water tank is full and
therefore the protection system
has been activated.
There is a problem with the hose.
Waste-water tank is not
assembled correctly.
The air inlet sponge is blocked.
Solutions
Disconnect the plug and
reconnect it.
Contact the official Cecotec
Technical Support Service.
Place the power switch in
the on position.
Empty the water from the
waste-water tank and
replace it.
Check if the hose is
damaged, kinked or cracked.
Position it correctly.
Clean it or replace it with a
new one.
CONGA 2000 CARPET&SPOT CLEAN COMPACT
ENGLISH
47