cecotec CONGA 2000 CARPET&SPOT CLEAN COMPACT Bedienungsanleitung Seite 45

3. ASSEMBLY
1. Insert the nozzle into the appliance.
2. Remove the clean-water tank from the main body of the appliance. Fill the tank with clean-
water tank up to the "MAX" mark (the maximum water capacity is 0.8 l) and install the
clean-water tank back into the main body of the appliance. Fig. 2
Warning
- You can add low-foam detergent to the clean-water tank, combined with water in a 5:10
proportion.
- After using the appliance, you must empty the remaining water in the clean-water tank to
avoid leakage and mould formation.
- Do not shake the clean-water tank during installation, as it could cause water leakage.
4. OPERATION
1. Connect the appliance to the mains socket.
2. Press the power switch to switch on the appliance.
3. Press and hold the water release button to spray clean water. Spray clean water on the dirt
to bring it to the surface.
4. Press the suction inlet on the dirt to bring water and dirt to the surface and vacuum them.
Fig. 3
5. Stop spraying clean water and vacuum the waste water.
6. Switch off the appliance by pressing the power switch.
7. Unplug it from the power supply.
8. Empty the clean and waste water from the tanks and clean the waste-water tank.
Warning
- It is normal for the surface to be wet after spraying.
- Do not spray water continuously over the same spot.
- Switch off the appliance before unplugging it.
- After using the appliance, hang and wind the power cable in the power cable holder.
Cleaning embedded dirt
ATTENTION
- You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
- Make sure the detergent will not damage the soiled surface before using it.
- Do not use thinners, aniline, chloroform, or flammable detergents.
CONGA 2000 CARPET&SPOT CLEAN COMPACT
ENGLISH
45