ENGLISH
Cleaning the spout, portafilter and filters
1. Turn the switch to the off position and then unplug the machine from the mains.
2. Some of the metal parts of the appliance may still be hot. Do not touch them until they have
cooled completely.
3. Remove the portafilter and clean any coffee residue. Wash both the portafilter and filter
with warm soapy water and rinse them well. Before placing them back in the appliance, be
sure to dry them thoroughly.
Note: do not wash the portafilter and filters in the dishwasher.
4. Wipe the bottom part of the spout with a damp cloth or paper towel to remove any coffee
grounds.
5. Place the portafilter (without any filter) in the coffee spout of the machine.
6. Place an empty large cup under the spout.
7. Next, plug the power cable into a power outlet. Place the power switch in the on position.
Press the Single Espresso icon once and let the machine spit out water until it stops.
Water tank cleaning
1. Empty the remaining water in the water tank. It is recommended that the water tank is
emptied every time the appliance is used.
2. Wash the tank and its cover with warm soapy water. Before placing them back in the
appliance, be sure to rinse and dry them thoroughly.
Note: do not wash the water tank or its cover in the dishwasher.
Warning: do not immerse the appliance or its power cable in water.
Cleaning the outer surface of the coffee machine
1. Clean the housing with a soft damp cloth. Do not use abrasive cleaning agents or abrasive
sponges as they may damage the finish.
2. Do not leave the portafilter in place when storing the appliance.
Descaling
-
The accumulation of mineral deposits in the appliance may affect its operation. Therefore,
we recommend that you descale the appliance when you start to notice an increase in
brewing time or when excessive steam is produced. You may also notice a build-up of
mineral deposits in the nozzle. The frequency of cleaning depends on the hardness of the
water used. The recommended cleaning intervals are given in the table below.
Water type
Cleaning frequency
Soft (filtered) water
Every 80-100 drink preparations
58
POWER ESPRESSO 20 CREAM
Hard water (tap water)
Every 40-50 drink preparations
Descaling the water tank
1. Fill up the water tank with a descaler agent following the proportions indicated by the
descaler manufacturer.
2. Rinse the water tank thoroughly. To do this, fill it halfway with tap water and then drain this
water. Repeat this process twice.
Descaling of internal parts
1. Before descaling the internal parts of the appliance, be sure to descale the water tank first
by following the steps before.
2. Make sure that the power switch is in the off position and the power cable is unplugged
from the power outlet.
3. Fill up the water tank and the milk tank with a descaler agent following the proportions
indicated by the descaler manufacturer and follow the manufacturer's instructions.
4. Insert the portafilter (with filter, but without coffee) and place a large empty cup on top of
the drip tray and under the spout.
5. Next, plug the power cable into a power outlet.
6. Place a large cup under the milk frother.
7. Place the power switch in the on position. When the icons on the display have stopped
flashing, press the Cappuccino or Double Latte icon. The appliance will start dispensing hot
water through the milk frother. Run several cleaning cycles.
Note: make sure that the water level in the water tank is between the "MIN" and "MAX" marks.
5. TROUBLESHOOTING
Problem
Possible causes
No water in the water tank.
Coffee is too fine.
No coffee
There is too much coffee in the filter.
comes out
The appliance is not connected to the
mains or switched on.
Coffee has been tamped/compressed
too much.
ENGLISH
Possible solutions
Add water.
Grind medium-ground coffee.
Fill filter with less coffee.
Connect the appliance to a power
supply and turn it on.
Fill the filter with ground coffee
and press it firmly.
59
POWER ESPRESSO 20 CREAM