Pari BOY Gebrauchsanweisung Seite 77

Procedure
• Wipe the outer surface of the housing with a clean, damp
cloth.
For disinfection, use a standard, alcohol-based disinfectant (e.g. isopropanol).
When applying and dosing the disinfectant, it is essential to follow the instructions
for use for the product.
• If the compressor is visibly dirty, clean the compressor before disinfecting it.
• Moisten a cloth with the disinfectant.
• Wipe off the outer surface of the housing thoroughly with the cloth.
• Let the disinfectant dry completely on the surfaces.
The procedure was validated in Europe using a disinfectant suitable for use on
plastics as per the DGHM and/or the VAH list: Propanol/Isopropanol
Validated using Incidin
• Inspect all product components after each cleaning and disinfection.
• Replace defective, deformed or seriously discoloured parts.
The air filter must be checked at regular intervals (after every 10th use). If it is dis-
coloured brown or grey, or if it is damp or clogged, it must be replaced.
The air filter cannot be cleaned and then reused!
Removing the air filter
• Pull the filter holder out of the compressor. Use a small
screwdriver, for example, to prise the filter holder care-
fully out of the compressor.
Replacing the air filter
• NOTE! For operating your compressor, use only air filters provided by the man-
ufacturer or distributor. If air filters not designed for the compressor are used, it
may be damaged.
Pull the old air filter out of the filter holder, and fit the new filter in its place.
• Insert the filter holder back in the compressor.
®
liquid.
33