Werbung
Verfügbare Sprachen
Verfügbare Sprachen
after turning the device off and on is auto mode.
EN
3. There are three modes of operation of the device: ECO – 55 minutes,
AUTO – 38 minutes, and TURBO – 11 minutes.
REPLACEMENT OF THE ROTATING ROLL
Note! Before replacing the roll, turn off the device and disconnect from the
power source.
1. Disconnect the turbo brush from the vacuum cleaner tube (fig. 4).
2. To pull out the roll, slide the switch on the bottom of the turbo brush (fig.
5). This will allow you to pull out the side valve (fig. 6). Remove it, and then
pull out the round roll (fig. 7).
3. Insert the roll for reinstallation (fig. 8), and then snap the valve into the
turbo brush (fig. 9).
Note! Pay attention to the exact installation of the round brush. Incorrect
installation may cause problems in the operation of the brush.
EMPTYING THE DUST CONTAINER
Note! Before emptying the container, turn off the device and disconnect it
from the power source.
1. Move the button (A, fig. 10), then unscrew the dust container (B, fig. 10)
and empty its contents.
2. Use the device only with the dust container properly applied. Correct
installation will signal a click.
CLEANING THE DEVICE
Note! Before cleaning, turn off the device and disconnect it from the power
source.
1. Empty the dust container (see: Emptying the dust container).
2. The microfiber filter and filter system can be washed under running water.
The HEPA filter should be replaced every 6 months or so. Clean the dust
container and tubes with a damp cloth (fig. 11).
ADDITIONAL INFORMATION
1. If you notice a decrease in suction power, clean the filters first.
2. Do not leave the device to dry in the sun or in a humid place.
3. Note! Do not wash the filter elements in a washing machine and do not
dry them with a hair dryer.
4. Note! Be careful when cleaning the filters. Do not use a brush to clean the
filters. Make sure all elements are dry before putting them in the vacuum
cleaner.
Werbung
