LOTTO OPTIMA Benutzerhandbuch Seite 7

EN
USING INSTRUCTIONS
1. Using treadmill
Insert the power plug properly and turn on the switch(in red color)(1). When the light is on, there will be
a beep sound, and then the screen will light up.
2. Safety key Introduction
The treadmill can only start when the safety key is put on the yellow area of the console. Clip the safety
key on clothes when using the treadmill to prevent accidents. Put the safety key back when continue
using the treadmill.
3. Console instructions
Button instructions
Start: When the treadmill is in standby condition, press Start to start the treadmill
Stop: When the treadmill is running, press Stop to stop the treadmill. All the data will be cleared and the
treadmill goes to manual mode.
Program:In standby mode, press Program can cycle the options from manual mode to automatic pro-
grams. Manual mode is the system defaulting running mode.
Mode: In standby mode, press Mode can cycle the options of 3 different countdown running mode: time
countdown running mode, distance countdown running mode and calorie countdown running mode.
When choosing any mode, speed adjusting buttons can be used to set the value. Press Start to start the
treadmill after setting the value.
Play/Pause: When playing music, press Play/Pause to pause the music, and press the button again to
play music again.
Volume+ -: Can be used to adjust the volume. If there is no sound, press Volume + to increase the vol-
ume.
Speed + -: Can be used to adjust the speed of the treadmill.
Speed direct selection: When the treadmill starts, press 3, 6, 9 buttons to change the speed directly.
Display Function
Speed display: Display the current running speed value.
Time display: Display the time of manual mode and the countdown time under automatic modes and
programs.
Distance display: Display cumulative distance under manual mode and programs. Display the distance
countdown in automatic mode.
Calorie display: Display cumulative calorie under manual mode and programs. Display the calorie count-
down in automatic mode.
Heart rate display: Heart rate signal will be detected, and the screen shows the heart rate number.
Heart rate measure function(optional): In the case that the treadmill is energized, hold the heartbeat
sensor piece for a while and the heart rate will be shown on the screen. (This data is for reference only,
it cannot be considered as medical data. )
7