Optimum Time OE Serie Bedienungsanleitung Seite 3

o
OPTIMUM
0
0
MIN
SEC
(3)
START
STOP
START
STOP
o
TIME
o
CLEAR
0
MIN
SEC
MODE
OPERATING INSTRUCTIONS
TO SET THE TIME
Put the watd-' into clock mcde by the MODE button (The Cicn:krnodecanbe
by the flashing colon between the hours and minutes digits and also by either AM or PM beng
visible at the top ot the display
2. Press the CLEAR button and hold it down
flash the hours digits
3. Press the MIN (minutes) button until the correct hour is shown
Notes a) Each time you press the button the clock will advance 1 hour
b) Keeping the button pressed in for a couple of seconds will start tast scrolling through the hours
c) The dock is a 12 nour clock with AWPM indicator
4. Che the correct hour is Set. press the MODE button. This will confirm the hours and make the minutes
tiasn Use the button to alter the rrunuteS In the same way as the hours were set.
S. Once the correct hours and mtnutes are set, press the CLEAR button one more time and the dock
set and running.Thedisplaywill also stopflashing.
TO LEAVE THE CLOCK FUNCTION
press the MODE button This will change the watch from TIME to COUNTDOWN timer
Press MODE again to change to COUNTUP timer
2.
3. Press MODE again to change to go back to tne CLOCK to see the time of day
tt is possible to use MODE to from dock to timer and timer to clock whether the timer iS
4,
running or not,
5. Once in timer there are 2 options COUNTDOWN Or COUNTUP. Once user programmed
countdown or user programmed countup has been chosen the Other option is not available
i e it the user programs the time in countdown. then there is no
tt the user programsthe time in countup,thereis no optiontor programmablecocmtdown.
recognised
approximately 2 Seconds until the display begins to
for programmable couniup