TRENDnet TEW-740APBO Schnellinstallations-Anleitung Seite 5

Phase 2: TEW-740APBOUnit #1 Hardware Setup and Configuration
1. Removethe cover of the access point by pulling and holding the tab in the vertical direction
upward (based on the access point orientation below) and sliding the cover in the two
locations noted below away from the access point.
2. Write down the MAC address (WiFi MAC)of the TEW-740APBO #1 access point. The MAC
address (WiFi MAC)can be found on the inside of the device cover where the Ethernet LAN
ports are located (shown below).
WIFI MAC: XXXXXXXXXXXXXXXXX
ETH
Pull and hold tab
LANI MAC: XXXXXXXXXXXXXXXXX
No: TEW.740APB0 A SN XXXXXXXXXXXXXXX
HW: V2.0RFW: V2_xxxxx
Made in XXXXXX
3