Blaupunkt RVC201 Bedienungsanleitung Seite 6

RVC201
I Power button
2 Top cover
3. Internal dust container
Bumper
4
5. Front wheel
BEFORE THE 'RST USE
Remove all papers, cartons and foils protecting
Remove the insulation foil from between the battery and the contacts. Make sure the battery is
2.
inserted correctly according to its polarity.
Install the collector
3.
marked with Lor R.
Set the device in the middle of a larger area, and run the cleaning programme until the battery is
4.
discharged. Charge the device battery
CHARGING THE DEVICE
1. Make sure that the device battery is correctly installed in the device before charging it.
2. Plug the power supply plug into the vacuum
socket. The blue LED on the power button will blink.
3.When the battery is fully charged, the LEDwill be lit continuously. Charging the battery takes
approximately 4-5 hours.
4. It is recommended to fully charge the battery without interruptions. This will extend the battery life.
DEVICE START-UP
Prepare the surface of the room to be cleaned. Remove sensitive objects, cables, sheets of paper. Raise
backdrops, curtains,
Press the on/off button to start the robot vacuum
periodically changing modes.
Random
The robot will run until the battery
doorsteps, or turned off by means of the on/off switch.
The robot will inform you that the battery
switch.
CLEANING AND MAINTENANCE
1. Emptying and cleaning the dust container.
Open the top cover by lifting
Empty the container.
The container may be cleaned under running water (do not wash in a dishwasher or washing machine).
Clean the filter with
brushes. Press the brush marked with L or R into the appropriate
according
and drapes hanging
Spiral
is discharged
it up. Pull out the container.
a soft brush.
6. Drive wheels
7. Collector
8. Suction opening
9. Surface-edge
10. Battery compartment
the vacuum
to the instructions.
cleaner, then plug the power supply into an electrical
to the ground. Cover delicate furniture.
cleaner. The robot will start to move and clean,
Along the wall
or until it is blocked by objects
is low by lighting up the red control
Remove the cover and the internal
4
BLAUPUNKT
brushes
sensors (Anti-fall)
and its parts.
Spiral
lying on the floor,
LED on the on/off
spot
filter.