Folding Instructions - grabner speed Benutzerhandbuch

fOlDiNG iNSTrUCTiONS

► Roll up the boat from bow to stern (di-
rection towards valves) so as to allow
discharge of air.
► Unroll and place the boat flat on the
ground, the eyelet studded coaming
should meet in the middle.
► Place the transom-panel inside and flap
the stern-cones over the transom-panel.
► Fold sides inward so that they form one
line lengthwise.
► Start firmly rolling the boat from rear to
bow.
► Fold the bow over to the inside of the
roll and continue until finish.
8
CaUTiON: Make sure there is no air left
in the boat!
► Lace the rolled up boat by means of a
line or strap.
CaUTiON: The boat must not be stored
in this state for longer periods! (refer
„care and storage")
► You may now pack your boat and stan-
dard accessories into your pack-bag or
rucksack (special accessory).
CaUTiON: Check for completion of all
parts!
► If you still find residue of air inside air
chambers of the boat, you may not be
able to successfully stow your boat into
your bag or rucksack.
(In the event of that unroll the boat and repeat
the process of rolling up once more).
HaNDliNG + DETailS
COrrECT TriM
Trim when under way
The seat-boards are arranged in a manner,
that the boat floats level. That extends the wa-
terline length and ensures better directional
stability. There is plenty of room midships for
luggage or a third person.
Trim when under way single hand
When under way single hand, place the rear
seat-board in midship position.
MOTOriSED OPEraTiON
Engine performance
Maximum engine output for your SPEED is
6 HP / 4.4 KW.
Subject to load, the boat enters the state of
planing as from appr. 4 HP.
WarNiNG: Never use an engine exceed-
ing the recommended output as stated per
manufacturers specification label or man-
ual. you would contravene the law, and
risk loosing control over your boat.