Unox Pure Betriebsanleitung Seite 19

Replacement of the filtering cartridge
The fi ltering cartridge XC216 must be replaced:
• As soon as the fi ltering capacity is reached, when the oven display shows the warning message
"WPURE".
Once the maximum capacity is reached, the parameter PIN value is set at zero (PIN = 0).
The alarm message, then, appears every time the appliance is turned on and it can be switched
off by pushing
NOTES: not replacing the exhausted fi ltering cartridge may cause inside the oven, depending
on the water hardness, deposits of calcium and magnesium carbonates.
• maximum after 12 months from the setting at work of the appliance.
Attention: while replacing the cartridge it is important to carefully check all the appliance
!
components: faulty components must be replaced and dirty components must be cleaned!
Before proceeding with the replacement of the cartridge, carefully read the operation and safety
indications. In case the appliance is stored or transported at temperatures lower than 0 °C, leave
the appliance with original packaging at indicated environmental temperatures for at least 24 hours
before setting at work.
Warning: when the docking handle is open, the water delivery to the cartridge is interrupted; a
closed circuit working is possible with a direct connection from the water inlet 4 and the water outlet
3 (if necessary, close the water fl ow and disconnect the oven electric power).
Instructions for fi ltering cartridge replacement
• Open the locking handle
• Push the rinse valve
• Take out the exhausted fi ltering cartridge
cartridge weight.
Note: to make this operation easier, turn the cartridge of 90° on the wall bearing.
Reset of the liter-counter function (PIN activation code)
Once the cartridge is replaced, to reset the liter-counter function, necessary for the following
replacement, proceed as follows:
1. Enter Programs menu by pushing
2. Push buttons until the display shows "PURE" message.
3. Enter parameters menu by pushing
Note: it is possible to exit at any time by pushing
4. Scroll down the parameters by pushing
5. Push button to display activation number value. Default value is set at 0.
6. Keep the buttons
packaging.
7. To store the set value push
Note: in case a parameter different from that one indicated on the fi lter packaging is stored, the
counter-liter function is not activated and "PIN" value is set = "0".
Example – First Installation with PIN=12345: Page 17
button.
.
2
and depressurize the system.
8
button.
button.
pushed until the display shows the value indicated on the fi lter
button for 5 seconds. The display shows "PIN".
from the fi lter head
6
button.
buttons until the display shows "PIN" message.
19
. Pay attention to the
1
English