Changing The Batteries - Dual Cd 5070 Rc Bedienungsanleitung

— The memory is ready for programming once all stored tracks have
been played and the player is in the stop position
— orafter the player is returned to the stop position by pressing the key
E Stop 4 while a program is being played.
— Individual memory locations will be displayed by pressing the key
Memory enter 14 again.
— The memory location displayed can be reprogrammed.
— The track stored in this memory location will be cleared by pressing
the key Memory clear 13 once.
Clearing memory entries
— Press the key Memory clear 13 twice while the program is being
played.
— The program will also be cleared after opening the disc tray or after
switching off the player by means of the key Power 1.
Remain display for remaining playing time
Press key Remain 11 to display the remaining playing time of all tracks
being played as well as the number of tracks still to be played. LED 17
displays the Remain function.
Remote control
The following functions can also be selected by the remote control
RC 75
— Stop, opening and closing the disc tray.
— Repeat.
— Forward and reverse search.
— Playback and pause.
— Reset to next lower track number.
— Skip forward to next higher track number.
— Programming desired disc tracks.
— Clearing memory entries.
— Direct selection of a disc track.
Changing the batteries
— The remote control RC 75 is powered by two 1.5 Volt-Mignon-cells
IEC R 6.
— The batteries must be changed if the range of the remote control
deteriorates.
— The battery compartment is located on the rear of the remote
control.
Important information
— Protect player from dampness.
— Fingerprints, dust and condensation on the compact disc can be
wiped off with a soft cloth.
Do not put the player into operating immediately after moving it from
the cold into a warm environment. Any condensation on the laser
lens may impair correct function.
Only operate the player in a horizontal position.
The disc should be removed from the player for transport purposes.
Disconnect from the mains before opening the player hou-
sing.
I
Caution
This CD player works with invisible laser light. After opening the player
housing, laser light will be radiated from beneath the disc support arm.
Do not look straight into the laser beam or expose any part of the body
to it.
Laser radiation within the player.
The player housing must only be opened by qualified personnel to
avoid harmful exposure to radiation.
Information label on the rear of the player (Fig. 2)
Warning label on the inside of the disc compartment (Fig. 3).
Electrical safety and interference suppression
The player complies with international safety regulations IEC 65
(VCE 0860) and EEC Directive 82/499/EEC (VDE 0875).
FRANGAIS
Power Interrupteur principal.
Enceinte pour disques, s'ouvre et se ferme en appuyant sur la
touche Open/Close 3.
A Open/Close.
Pour ouvrir ou fermer l'enceinte pour disques.
Touche Il Stop.
<< Rev Recherche rapide en arrière.
>» F. F. Recherche rapide en avant.
Il Pause
Touche pour interrompre la reproduction.
» Play Mise en route de la reproduction.
Phones Prise pour casque d'écoute stéréo à valeur ohmique
moyenne ou haute, avec fiche jack 6,35 mm.
Réglage du volume pour la sortie casque d'écoute.
oe ON O ob OQ NH
10
10 Ly Repeat Répétition.
Appuyer 1 fois: Répétition d'un morceau
(Affichage: One Repeat).
Appuyer 2 fois: Répétition du disque entier ou du programme
(Affichage: Repeat all).
En appuyant à nouveau sur la touche, la fonction Repeat est
inactivée.
Remain
Le display affiche les morceaux qui sont encore a jouer ainsi que le
temps restant pour tous les morceaux.
Skip
144 Touche de retour au numéro du morceau precedent.
PPI Touche de retour au prochain numéro de morceau.
11
12