cecotec Ready Werm 6650 crystal connection white Bedienungsanleitung Seite 25

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Main body
2. Control panel
3. Feet
4. On/Off switch
Please note
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If any of them
are missing or not in good condition, please contact the official Cecotec Technical Service
immediately.
- Make sure the side power switch is set to the OFF position.
- Plug the device to an earthed wall socket.
3. PRODUCT ASSEMBLY
Floor assembly
Attach the feet support to the product's bottom part using the ST12 x 4 mm screws provided
as shown in figure 2.
Wall assembly
Warning:
When installing the product, make sure to leave a minimum safety distance of 15 cm from the
floor to the device and 50 cm from the ceiling.
1. Remove the installation bracket at the rear of the unit by removing the fixing screws as
shown in figure 3.
48
2. Present this wall bracket at the location where it is to be installed, then mark the bracket
holes on the wall (make sure the bracket is level) at the ends of the bracket.
3. Using a drill, make holes in the wall of the same diameter as the fixing screws. Insert a
fixing dowel into the previously drilled holes.
4. Fix the bracket to the installation wall using the screws as shown in figure 3, make sure
that the screws are aligned with the holes.
5. Once the wall bracket has been correctly installed, you can fix the appliance in place by
moving the appliance closer to the wall and reattaching the screws removed in step 1.
6. Distance between holes (screws 4x35 mm):
Reference: Model
05318 ReadyWarm 6650/6670
05350 Crystal Connection
05319 ReadyWarm 6700/6720
05351 Crystal Connection
05320 ReadyWarm 6750/6770
05352 Crystal Connection
4. CONTROL PANEL
The buttons on the product control panel correspond to those that will appear in the application.
Fig. 4
1. Display
2. Increase button
3. Decrease button
4. Power button
5. Mode button
6. Timer button
7. Receiver
8. Child lock button
5. OPERATION
Power
- Turn on the side power switch.
- Press power button to start the device and enter the function settings. The upper part of
ENGLISH
Distance between the holes
28 cm
44 cm
60 cm
49