Hama RC700 Bedienungsanleitung Seite 7

Normal mode 12/24 Hr format setting
Languagel mode
Time difference setting
ALARM TIME SETTING
1. In normal time mode, press and hold "ALARM SET" key for 2 seconds until the Hour digit
flashing
2. press "DOWN" / "UP" keyto adjust the value Ofthe flashing digit
3. Press "ALARM SET" key again to step the setting value to Minute with the Minute digit
flashing
4. Press "DOWN" / "UP" keyto adjust the value of the flashing digit.
5. Press "ALARM SET" key to save and exit the setting.
Normal mode
12
Hour setting
Minute settlng
Year setting
Date setting Month setting
Hour setting Minute setting
USING ALARM AND SNOOZE FUNCTION
1. Set the desired alarm time as described
2 Push "ALARM ON/OFF" slide switch to "ON" position to turn on alarm function with the icon
displayed on the LCD
3. When clock reach the alarm time, alarm sound will start Where, it can be stopped by
following operation:
a. Auto-stop after ong minute alarming if without any operation and itwill re-alarm by the
next day.
b. By pressing "SNOOZE" key to enter snooze that the alarm will sound again after 5 minutes
(One minute alarm and 4 minutes snooze).
c. By sliding "ALARM ON/OFF" switch to "OFF" position to turn offthe alarm function
Note:
1 The snooze could be used continuously in 24 hours
2. During the snooze, the alarm icon will keep flashing
NIGHTLIGHT
1 push "Night-light" slide switch to ON position to turn on night light function, the backlight will
automatically turn on in dim & dark environment detected by the night-light sensor
setting
2. Push "Night-light" slide switch to OFFposition to turn off night light function
Note:
The brightness of nightlight is weaker than normal backlight
USING THE COUNTDOWN
In normal mode, press "TIMER" keyto turn to timer mode with the "TIMER" displayed on the
LCD
press"DOWN"/ "UP" keyto setthe desiredcountdowntime
3 Press "SNOOZE/LIGHT" key to start the countdown
4 During the countdown, press "SNOOZE/LIGHT" key again to stop the countdown.
When the timer is stopped, press and hold "TIMER" key to return the time to 1: 00. Or pres
"TIMER" key to return to normal mode.
Pre-set time
Note:
1. The maximum setting countdown time is 12 hours. And the minimum setting countdown time
is 1 minute
2 During the countdown period, the icon " " keeps flashing until the countdown Stops
in the above section.
FUNCTION
TIMER
Countdown to O Return to pre-set time
13