Service; Storage And Transportation - Dnipro M Rw-12 Originalanweisungen

Charging the battery (Fig. 7)
WARNING!
It is recommended to charge the
battery at an ambient temperature
of 0 °C to +50 °C.
– Disconnect the battery from the ratch-
et.
– Connect the charger to the mains. The
green indicator (2) flashes to indicate
that the charger is connected to the
power supply.
– Install the battery (4) in the appropriate
section (3) of the charger.
– The indicator (1) on the charger will
light up in red, indicating the process
of charging the battery.
– During the charging process, the indi-
cator will change from red (1) to green
(2), indicating that the battery is fully
charged.
– After charging, remove the recharge-
able battery (4) from the charger (3)
and disconnect the cable of the char-
ger from the mains.
Charger indicators:
(1) red indicator.
(2) green indicator.
– The red indicator is off, the green indi-
cator is flashing: the battery is not con-
nected or has failed (no load on the
charger).
– The red indicator is on, the green indi-
cator is off: the battery is charging.
– The red indicator is off, the green indi-
cator is on: the battery is fully charged.
– The indicators are blinking - the battery
pack is out of order, contact the manu-
facturer (DNIPRO M LLC), the DNIPRO-M
authorized service center, or the seller
of the product.
Battery charge indicator (Fig. 8)
– The charge indicator has three charge
levels:
– If all the indicators are lit, it means that
the battery is charged to 75-100%.
– f two indicators light up, this indicates
that the battery is charged to 25-75%.
– If only one indicator lights up the bat-
EU-RW0923001-1023003
tery is charged to 10-25%, it is neces-
sary to charge it.

9. SERVICE

Unless otherwise expressly provided for
in this manual, the product must be ser-
viced only by the manufacturer (DNIPRO
M LLC), the DNIPRO-M authorized service
center, or the seller of the product.
Regularly (preferably after each use) wipe
the body of the power tool with a soft
cloth. Make sure that there is no dirt and
dust in the ventilation openings. If the
ventilation openings are heavily soiled,
blow them out with compressed air.
Do not use solvents such as gasoline,
aqueous ammonia solution, etc., as they
may damage the plastic parts of the pow-
er tool. Make sure that moisture does not
get into the openings on the body of the
power tool.
10. STORAGE AND
TRANSPORTATION
It is recommended to store the power
tool in a dry place inaccessible to chil-
dren, protecting it from direct sunlight,
at a temperature from -5 °C to +40 °C and
a relative humidity of no more than 80%.
It is recommended to store the battery at
an ambient temperature of +25 °C.
If you have stored or transported
power tool at a temperature lower than
that at which it is intended to be used, it
is necessary to ensure there is no conden-
sation on the power tool. If condensa-
tion forms on the components and parts
of the power tool, its further preparation
for work or operation is prohibited until
the condensate dries completely.
It is recommended to store the power
tool, the original safety and operating in-
structions, and accessories in the original
packaging. In this case, all necessary in-
formation and details will always be avail-
able.
To transport the power tool, use the orig-
inal or other packaging that excludes
damage to the power tool during trans-
portation.
en
the
9