Safety Instructions When Working With The Impact Ratchet; Conventional Signs And Symbols - Dnipro M Rw-12 Originalanweisungen

en
not charge the battery or power tool
outside the temperature range speci-
fied in the instructions. Charging out-
side the instructions or outside the
temperature limits can damage the bat-
tery and increase the risk of fire.
Service
– Take your power tool for service to the
manufacturer (DNIPRO M LLC), DNI-
PRO-M authorized service center, or to
the seller of the product. This will en-
sure the maintenance of safety and ser-
viceability of the power tool.
– Never repair damaged batteries your-
self. Repair of batteries by the manufac-
turer (DNIPRO M LLC), DNIPRO-M autho-
rized service center, or by the seller of
the product.
2. SAFETY INSTRUCTIONS WHEN
WORKING WITH THE IMPACT
RATCHET
– Do not touch the rotating parts of the
power tool.
– Hold the ratchet firmly in your hand
while working.
– When the tool is locked, immediate-
ly turn off the ratchet! Do not switch
on the power tool if the accessory is
locked: kickback may occur.
– When screwing the fastening elements
into the walls, ceiling and floor, make
sure that there are no hidden electric
cables, gas and water pipes at the work
point.
– Do not use damaged accessories, as
this increases the risk of damage to the
power tool.
– Do not disassemble the power tool and
battery, and do not subject them to
shocks.
– Do not touch the terminals of the bat-
tery with objects that can conduct
electric current. A short circuit can lead
to a decrease in voltage, overheating of
the battery as well as thermal burns due
to heat generation and complete failure
of the battery.
– If the electrolyte gets on the skin, it
must be washed off immediately with
6
soap and water. If the electrolyte gets
into the eyes, it is necessary to wash
them thoroughly and consult a doctor.
– Do not keep the battery near metal ob-
jects (power tools, fasteners, coins,
etc.).
– Do not cover the charger while charging
the battery, it may overheat and mal-
function.
– Do not overload the power tool.
– The power tool must be repaired exclu-
sively by the manufacturer (DNIPRO M
LLC), the DNIPRO-M authorized service
center, or the seller of the product.
3. CONVENTIONAL SIGNS AND
SYMBOLS
General caution sign (risk to
people, explained by an addi-
tional sign or text)
See instruction manual/brochure
Wear eye protection
Direct current
n Idle speed
0
Li-Ion Battery type
Degree of protection against
IP
dust and water
Symbol of the possibility of sec-
21
ondary treatment
Class of protection against elec-
tric shock
Mark of conformity with techni-
cal regulations (Ukraine)
A special mark that certifies that
the product meets the main re-
quirements of EU directives and
harmonized standards of the Eu-
ropean Union
The only sign of circulation of
products on the market of mem-
ber states of the Eurasian Eco-
nomic Union
EU-RW0923001-1023003