Preparation For Work; Working With A Cordless Impact Ratchet - Dnipro M Rw-12 Originalanweisungen

en
Information on noise and vibration
The declared total noise and vibration
value has been measured according to EN
62841-2-2 and
can be used to compare one power tool
with another.
The declared level of noise and vibration
can be used in preliminary assessments of
exposure to noise and vibration.
WARN ING!
Vibration transmission and noise
emissions during the actual use of
the power tool may differ from the
declared values depending on how
the power tool is used, especially
what type of material is being pro-
cessed. Use personal protective
equipment according to work con-
ditions.
The declared level of noise and vibration
refers to the work for which the power
tool is intended.

7. PREPARATION FOR WORK

WARN ING!
Before preparing for work, during
maintenance
work with the power tool, discon-
nect the battery from the po wer
tool.
Unpack the power tool and inspect the
package for external damage. If you have
stored or transported the power tool at a
temperature lower than that at which it is
intended to be used, it is necessary to en-
sure that there is no condensation on the
power tool. If condensation forms on the
components and parts of the power tool,
its further preparation for work or oper-
ation is prohibited until the condensate
dries completely.
Installing/removing the battery
(Fig. 2)
– Connect the battery (2) to the power
tool in direction (A). Before installing
or removing the battery, lock the pow-
er key (3).
8
and after finishing
– It is not recommended to exert exces-
sive effort when installing the battery.
If the battery is installed with effort, it
means that the installation steps are
not performed correctly or a foreign
object has fallen into the grooves of the
case. To remove the battery, press the
battery latches (1) and, without releas-
ing them, pull the battery in the direc-
tion of the arrow (B) (Fig. 2).
Installing the accessories
Install the necessary accessories (2) on
the 3/8-inch mounting square (1) (Fig. 3).
Adjusting the rotating direction (Fig. 4)
Set the direction switch (1) to position F
(twisting) or R (untwisting), check the di-
rection of rotation by briefly pressing the
power key.
WA RN IN G!
Changing the direction of rotation
is allowed only when the power
tool is turned off.
Locking the power key (Fig. 5)
– The locking lever (2) of the power key is
designed to prevent accidental switch-
on. Always lock the power button (1)
in position (1) if you are not working or
taking breaks in working with the ratch-
et.
– To unlock the power key, you need to
move the locking lever to position (2).
8. WORKING WITH A CORDLESS
IMPACT RATCHET
WA RN IN G!
It is recommended to work with the
power tool at an ambient tempera-
ture of -10 °C to +40 °C.
Work
Place the accessory (1) on the nut or
screw (2) (Fig. 6), press the power but-
ton and start the unscrewing or tighten-
ing process. The speed of the power
tool increases by increasing the pressure
on the power button. Keep the power key
pressed until you're done.
EU-RW0923001-1023003