Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preparations
Parts of the seat
1.
Adjustable Headrest
2.
Should Belt Guide
3.
Booster
4.
ISOFIX Locking Arms Release Handle
5.
Lap Belt Guide
Installation of the seat
When installing the booster seat in the
—
front seat of the vehicle, ensure the vehicle
seat backrest is upright.
Adjust the back seat's backrest to upright
—
position, if possible.
Position the seat inside the vehicle.
—
Pull the ISOFIX locking arms release
—
handle to release the ISOFIX connectors.
Click the ISOFIX connectors to the
—
anchorage points in the vehicle seat.
Ensure that all indicators are GREEN.
Push the booster seat until it firmly
—
touches the vehicle's backrest. Any angle
and distance are allowed, if it is firmly
touching the vehicles backrest.
Remove the vehicle seat headrest if it
—
blocks the booster seat adjustment.
Reinstall it when the booster seat is
removed.
If the seat cannot be used with both ISOFIX
—
and 3P belt, you can store the ISOFIX
locking arms in the booster seat and only
use the vehicles 3P belts.
Adjusting the headrest
You can adjust the Headrest (1) by using the
Headrest Height Adjuster (7). Make sure
there's no more than 2 cm (about 2 fingers
width) between the child's shoulder and the
headrest.
Positioning of the child
Slide the shoulder belt into the shoulder
—
belt guide.
Have the child sit in the booster seat.
—
Position the vehicle belt in front of the
—
child and lock it into the buckle.
Adjust the headrest to match the child's
—
shoulder height.
Tighten the shoulder belt and ensure it is
—
not twisted.
6.
Backrest
7.
Headrest Height Adjuster
8.
ISOFIX Locking Arms
9.
ISOFIX Release Buttons
10. Instruction manual Storage Area
Removing the seat
Perform the installation steps in reverse
order.
Slide the shoulder belt out of the guide.
—
Release both ISOFIX connectors, by
—
pulling the ISOFIX release handle.
Remove the seat from the vehicle and
—
push the ISOFIX locking arms back into
the transport position.
Removing and re-attaching the seat
cover
The car seat cover is made up of three parts:
the headrest, backrest, and booster. These
parts are secured with press studs and elastic
bands. To remove the cover, release all
attachments and take off each part. To
reattach the cover, simply reverse the removal
steps.
Care and maintenance
Avoid
using
—
gasoline, or other solvents to clean the car
seat as they can cause damage.
Remove the car seat from the vehicle when
—
not in use and store it in a cool, dry place
out of your child's reach.
For washing instructions, refer to the label
—
inside the fabric cover.
undiluted
detergents,
Werbung
