Werbung
Verfügbare Sprachen
Verfügbare Sprachen
be pressed to change the unit, and the power switch can be stopped by pressing the On/Off
Switch button.
8. When the pressure reaches the set value, the air pump will automatically stop working.
9. After inflating, pull the plug from the 12V DC socket.
10. When not in use, disconnect the hose from both the air pump and the airbag, and store it
properly.
11. Press the On/Off Switch button to start the air pump. First, the fast charging pump works.
When the pressure value reaches 1PSI, it is automatically converted into high-pressure
inflation until it reaches the set pressure value.
12. Usually press the On/Off Switch button for 3 seconds, directly start the high-pressure
inflation, short press the On/Off Switch button for power switch.
13. When the device is powered on, it may have issue of inconsistent readings under zero air
pressure condition due to geographical and environmental influences. Press and hold the
PSI/BAR exchange button for 5 seconds to recalibrate and resolve the issue.
Note:
The air pump has a memory of the pressure value used last time. The pressure value for the
•
next use will display the pressure value set last time by default.
When the air pump is powered on and does not operate for 2 minutes, it will enter standby
•
mode. You can press any button to activate the system.
Deflation Operation
1. Remove the hose from the inflation port, then connect one end of the hose with the air
pump outlet and tighten it clockwise (Drawing 3). The other end is still connected to the
airbag.
2. Press the On/Off Switch button of the air pump to start venting until all the gas is discharged,
then the power can be turned off and the air venting can be stopped.
EN
Werbung
