Access MICROWAVE PROGRAMMER Bedienungsanleitung Seite 22

MICROWAVE PROGRAMMER
For editing puposes,you can selectseveralinstrumentsin succession for any desired
combination
Press the WAVE EN V 5-8 key to exit Instrument
NOTE:
- In Instrument Select Mode, the rotary pots no longer send MIDI data!
- The Programmer defaults to Instrument 1 when turned on.
TRI/SQU/SAW
The TRI, SQU and SAW keys let you selectthe triangular, squareand sawtooth waves
available at the end of each wavetable individually for both oscillators.
In contrast to the START WAVE controls, when you pressone of thesekeys, it switches all
modulations that affect the wavetable off; in other words, the following modulation options
are set to "0":
Wave Envelope Amount
Wave Envelope Velocity
Wave Keytrack
Wave Modifierl
Wave Modifier2
Pleasenote that the MICROWAVE PROGRAMMER cannot reconstruct modulations you
have switched off You must reprogram them via the Programmeror directly at the
Microwave.
If you want to utilize the TRI, SQU or SAW waveshapes with the given modulations,select
them via the START WAVE pot. Turn the STARTWAVE key all the way clockwise to the
maximum setting.The TRI/SQU/SAW LEDs will illuminate when the corresponding
Waveform
STARTWAVE
OWNERS MANUAL
or even all 8 instruments.
BUTTONS - STARTWAVE
TRI
Amount
Amount
Amount
is activated.
Select Mode.
SQU SAW
O
O
o
21