Sartorius YDP50 Betriebsanleitung Seite 16

Getting Started
5.3 Connecting the Power Supply Unit to the Power Supply
Procedure
Check whether the country-specific power plug matches the power
t
supplies at the installation site.
If required: Replace the country-specific power plug adapter.
t
NOTICE Damage to the device due to incorrect input voltage! Check
t
whether the voltage specifications on the manufacturer's ID label match
those of the power supply at the installation site.
If the input voltage is too high or too low: Do not connect the device to
t
the power supply.
Contact Sartorius Service.
t
Connect the power supply unit to the wall outlet (supply voltage) at the
t
installation site.
5.4 Switching the Device On or Off
Procedure
To switch the device on: Press the On | Off switch so that it is in the
t
"|" position.
The LED display lights up.
y
The device is ready for use.
y
To switch the device off: Press the On | Off switch so that it is in the
t
"o" position.
16 Operating Instructions YDP50