Product Overview; Area Of Application/Notes On Use; Transport, Storage; Disposal / Recycling - Systemair Aw Ec Betriebsanleitung

Operating Instructions AW EC

3 Product overview

3.1

Area of application/Notes on use

The fans / motors are not ready-for-use products, but conceived as components for ventilation
systems (type designation see rating plate).
The fans may not be operated until they are installed in line with their intended use. The supplied and
certified guard grille of ZIEHL-ABEGGSystemair GmbHSE fans is designed in accordance with
DIN EN ISO 13857 Table 4 (from the age of 14 up). In the event of deviations, further structural
protective measures must be taken for safe operation.
Any use below -10 °C is dependent on not being subjected to unusual, sudden or mechanical loads
•
or stresses on the material (see minimal permissible ambient temperature).
• Corrosion is possible at the cutting edges on sendzimir galvanised parts.
Warning
If the motor/fan is used in applications where a ignitable atmosphere can form in the event of a fault,
e.g. due to leakage, the user must assess the risks of ignition and take appropriate precautions to
prevent ignition.
3.2

Transport, storage

Warning
• Observe the weight specifications (see rating plate) and the permissible carrying loads of the means
of transport.
Wear safety clothing / shoes and cut-resistant safety gloves when handling!
•
• Do not transport the fan by the connecting cable!
• Avoid shocks and impacts to the device during the transport.
Avoid extreme humidity, heat or exposure to cold (see technical data).
•
Watch out for possible damage to the packaging or fan.
•
• Secure pallets during transport.
Do not stack pallets.
•
Only handle with suitable hoisting gear.
•
• Position the lifting beam transversely to the motor axis. Pay attention to adequate width of the lifting
beam.
Never stand underneath the suspended fan because defective transport equipment could cause
•
death.
Store the fan / motor in the original packaging in a dry area protected from the weather and protect
•
it from dirt and weather until final installation.
• Avoid prolonged storage; we recommend a maximum of one year (consult the manufacturer before
starting if stored for longer).
Inspect the bearing for proper operation prior to installation.
•
– Recommendation: Turn the impeller evenly by hand to avoid jamming and damaging the
bearing.
Transport the fan(s) either in the original packaging or, in the case of larger fans, on the dedicated
•
transportation fixtures.
– axial fans: holes drilled in support arms, wall ring plates and motor block
The fan must be fastened to 4 points during transport so the flanges do not warp.
•
3.3

Disposal / Recycling

Disposal must be carried out professionally and in an environmentally friendly way in accordance with
the respective national legal stipulations.
Separate the materials by type and in an environmentally-friendly way.
"
If necessary, commission a specialist company with the waste disposal.
"
L-BAL-F101-GB 2023/26 Index 001 Part.-No. 00712749-GB
6/18
Product overview