Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
D
1509)50-4
If you have a problem, read this
Your dishwasher may not work or not function properly. In many cases, these are problems which can be
solved without having to call for a technician. Before calling the service centre, always check the points
below.
The dishwasher won't
start
I Is the water supply tap turned
on?
I Is the water supply tap
connected to the hose properly?
I Has the water in your home
been cut off?
I Is the pressure of the water
supply sufficient?
I Is the hose bent?
I Is the filter on the water supply
hose blocked?
I Is the dishwasher door open?
The dishes are not
clean.
I Have you put the right amount
of detergent into the
dispenser?
I Is the wash cycle suitable for
the dishes you have placed
inside the appliance?
I Are the filter and microfilter
clean?
I Can the sprayer arms turn
freely?
Safety within your home
Your dishwasher was built in accordance with the strictest international safety regulations. They protect
you and your family. Read the instructions and information contained in this manual: they will provide
you with useful hints as to installation, use and maintenance safety. To avoid nasty surprises.
1.
Dispose of the packaging
material carefully (follow
the instructions on how
to divide your rubbish up
provided by your local
Council)
2.
After
removing
packaging, check to make
sure your appliance is
intact. If in doubt, contact
a qualified professional.
3.
Your dishwasher must
only be used by adults and
for washing household
dishes, according to the
instructions included in
this manual. Do not touch
the appliance with wet
hands or feet or barefoot.
4.
We discourage the use of
extension leads and mul-
tiple
plugs.
If
electricity supply wire is
not long enough, then
have it replaced with one
of the correct length and
remember that it should
be free of bends or
20 ARISTON DISHWASHER - Instructions for installation and use
Troubleshooting
The dishwasher won't
drain.
I Is the drain hose bent?
Limescale deposits or a
white film form on the
dishes.
I Is the lid on the salt container
closed properly?
I Is the rinse aid dosage correct?
Error messages
Your dishwasher is equipped with
a safety system which is able to
detect any operating anomalies.
These anomalies are reported by
one or two cycle indicator lights
"M" flashing rapidly. Take a note of
which lights are flashing, turn the
appliance off and call for technical
assistance.
Tap off alarm
If you have forgotten to turn the
water tap on, your appliance will
remind you of this by sounding a
few short beeps for a few minutes.
Turn the tap on and your appliance
will start up again after a few min-
utes. Were you to be absent when
these beeps are sounded, the appli-
dangerous kinks.
5. If the appliance is not
operating properly or if
maintenance operations
are necessary, disconnect
the dishwasher from the
the
mains power supply
(unplug it!).
6.
Keep children away from
the dishwasher when it is
open and keep detergents
out of their reach.
7.
Your dishwasher is not to
be installed outdoors, not
even if the area is covered
by a roof: it is extremely
dangerous to leave it
exposed to rain and
thunderstorms.
8.
Do not touch the heating
element
during
the
straight after a wash
cycle.
9.
Do not lean or sit on the
door when it is open, as
this could overturn the
dishwasher.
10. If
the
appliance
ance will be blocked automatically
and cycle 2 and 3 indicator lights
(daily wash and soak cycle) will
flash rapidly. Turn the appliance off
at the ON-OFF button, turn on the
water tap and wait approximately
20 seconds before turning the ap-
pliance back on, the wash cycle
will start up again.
Clogged filter alarm
If the appliance is blocked and
wash cycle1 and 3 indicator lights
(intensive and soak) flash rapidly,
this means the filter is clogged by
large particles of food residue. Turn
the appliance off, clean the filter
thoroughly and reposition it in its
seat as illustrated on page 21. Then
turn the appliance back on.
Re-select a wash cycle as indi-
cated in the "Selecting the wash
cycle" paragraph and the appliance
will start.
Water load solenoid valve
malfunction alarm.
If indicator light 2 (Daily wash)
malfunctions, turn off the
water inlet tap and
disconnect the plug from
the wall socket. Then try
consulting the section
entitled "I you have a
problem, read this". If you
cannot
resolve
problem, then call the
service centre.
11. Once taken out of use,
appliances must be made
inoperable: cut the power
supply wire and damage
the door lock.
12. The door should not be left
in the open position since
this could present a
tripping hazard.
13. Disposal of old electrical
or
appliances
The European Directive
2002/96/EC on Waste
Electrical and Electronic
Equipment
(WEEE),
requires
that
household
electrical
appliances must not be
flashes rapidly, TURN the
dishwasher OFF AND BACK ON
AGAIN after one minute. If the
alarm persists, first turn off the
water tap to avoid any flooding and
then cut off the electricity supply
and call for technical assistance.
You have checked
everything, but the
dishwasher still doesn't
work and the problem
persists?
Call an authorised service centre
near you and remember to
mention:
• the type of malfunction
• the model mark (Mod....) and
the serial number (S/N....)
indicated on the rating plate
located on the inner door, to one
side.
Never call upon
the services of
u n a u t h o r i s e d
technicians and
always refuse
spare parts
that are not
o r i g i n a l s .
disposed of in the normal
unsorted
municipal
waste
stream.
appliances
must
collected separately in
order to optimise the
recovery and recycling of
the
the
materials
contain and reduce the
impact on human health
and the environment. The
crossed out "wheeled bin"
symbol on the product
reminds you of your
obligation, that when you
dispose of the appliance
it must be separately
collected.
Consumers
contact
their
authority or retailer for
information concerning
the correct disposal of
their old appliance.
old
Old
be
they
should
local
Werbung
Inhaltsverzeichnis
