Starting The Dishwasher - Ariston LI 420 Gebrauchsanleitung

Ready, steady, go!
You have loaded your dishes and you now have to set the wash cycle. It takes just one minute to learn
how
First of all.
After performing all the op-
erations described in the
previous paragraphs, turn
the water tap on completely,
open the appliance door and
press ON-OFF button "A":
indicator light "B" comes
on. Your appliance is now
on and awaiting instruc-
tions.
Selecting the wash
cycle.
Select the wash cycle by
pressing button "P". Each
time this button is pressed,
one of the indicator lights
"M" will come on in se-
quence, select the wash cy-
cle you deem most suitable
for the type of dishes to
wash (take a look at page
17, where you will find the
wash cycle table). Close the
appliance door and after a
few seconds, you will hear
a short beep: the wash cy-
cle has begun.
Modifying a wash cycle in
progress.
But if you have chosen the
wrong cycle, not to worry!
You can modify the wash
cycle in progress, if it has
only just started. Open the
appliance door carefully to
avoid any hot water
splashes, then keep button
"P" pressed for approxi-
mately 5 seconds, until you
hear 3 short beeps. Indica-
tor light "M" will come off
and at this point, all the set-
tings will have been can-
celled. You are now free to
re-set the correct wash cy-
cle.
You can modify
the wash cycle in
progress, if it
has only just
s t a r t e d .

Starting the dishwasher

You've left out a dish?
Well, it happens to every-
one. Interrupt the wash cy-
cle by opening the appliance
door with the utmost care,
as usual, then insert the
dish you had forgotten.
When you shut the appli-
ance door, the cycle will
start up from where you in-
terrupted it.
Finished?
The end of the wash cycle
is indicated by a double
beep and the flashing of the
wash cycle indicator light
"M".
Warning!
Open the dishwasher
door, turn off by
pressing button "A", un-
plug the appliance from
the electricity socket to
cut off the power supply;
the power supply cable
should consequently be
easily accessible.
Turn off the water tap.
Wait a few minutes before
unloading the dishes: they
are very hot! If you wait a
little while, they dry better
thanks to the steam.
Empty the lower rack first.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and
then restarts when the
electricity comes back on or
when you close the door.
Everything is under control!
Make sure the
wash cycle has
ended before
removing the
d i s h e s !
ARISTON DISHWASHER - Instructions for installation and use
D
1509)50-4
If opening the door
soon after the end
of the
p r o g r a m m e , o r
during it, stand
away from the
Dishwasher, to
avoid possible
injury from hot
s t e a m .
15