Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
D
1509)50-4
How to load your dishes
Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer.
Remove the largest scraps of food left over on your plates, soak saucepans and frying pans with tough
incrustations. After loading your dishes, make sure the blades on the sprayer arm turn well
First of all.
Before placing the dishes in
the racks, remove the
largest scraps of food left
over on your plates, you will
thus avoid blocking the
filter, which would reduce
the efficacy of the wash.
If the saucepans and frying
pans are very dirty, allow
them to soak before being
washed. To make it easier
to load your dishes, pull the
racks out.
What goes into the
lower rack?
We recommend you place
the most difficult dishes to
wash into the lower rack:
saucepans, lids, soup dishes
and plates (a load example
is shown in the photo).
• Serving dishes and large
lids: place them on the
sides of the rack.
• Saucepans, salad bowls:
must always be placed
upside down
• Very deep dishes: place
them obliquely, thus
allowing water to run
down them and cleaning
them better
Insert the cutlery into
the basket: Knives and
other utensils with sharp
edges must be placed in the
cutlery basket with the
points facing downwards, or
they must be positioned
horizontally in the tip-up
compartments on the upper
rack. Position all cutlery
items so that they don't
touch.
If the rack has side baskets,
the spoons should be loaded
individually
into
appropriate slots (see fig.
A). It is best if you place
longer utensils horizontally
at the front of the upper
rack.
14 ARISTON DISHWASHER - Instructions for installation and use
After loading the dishes,
remember to check that the
blades on the sprayer arms
can turn freely without
hitting against any dishes.
What goes into the
upper rack?
Place
delicate
lightweight dishes in the
upper rack: glasses, tea
cups and coffee cups,
saucers - but plates too -
shallow
salad
slightly dirty frying pans
and shallow pans.
Position lightweight dishes
in such as way as to avoid
their being moved by the
spray of water.
The appliance can also be
equipped with 2 or 4 tip-
up compartments onto
which you can place mugs
and cups, as well as long
sharp knives and serving
cutlery.
How to adjust the top
rack.
The upper rack can be set
in high or low position to
enable you to organise your
dishes effortlessly.
1
3
Fig.F
Open the rail stop flaps and
pull the rack out completely.
Now place it in high or low
position, then slide it along
the guide rails until the front
wheels also go in. Now close
the
the rail stop flaps. Follow the
sequence of actions
illustrated in figure "F".
and
bowls,
Loading examples for the upper rack
Loading examples for the lower rack
2
4
A
Werbung
Inhaltsverzeichnis
