Fakir INOVATOR X PLUS Bedienungsanleitung Seite 36

INOVATOR X PLUS | 7286
EN
Dust canister (7)
Removing the dust canister:
• Detach the body of the vacuum cleaner with
the motor by pressing the vacuum wand
release button (19).
• Press the dust canister removal button (8)
and pull the nozzle of the vacuum cleaner by
pulling it towards you.
• If you feel that the vacuum performance of the vacuum cleaner is reduced, make sure
that the dust canister is not full and empty it if required.
NOTE:
We recommend you to empty the dust canister after each operation.
• You may open the dust canister by pressing button no. 6.
• After emptying the canister for 5 times in total, we recommend you to clean the filtering
system completely to remove the settled dust.
• Press the canister lock button (8) and then remove the dust canister (7) from the vacuum
cleaner.
• Pull the HEPA filter out of the canister by rotating the special air filter counter-clockwise.
Discharge the dust of the HEPA filter to a dust bin.
• You may wash the filter lightly under warm tap water running
slowly. Hold the filter at a specific angle, thus the water would
wash the dirt inside the plies.
• Rotate the filter 180° and ensure that the water flows in the
reverse direction from the plies. Continue this operation until
the filter is cleaned.
• After it is dried, place the filter so that the UP label faces
upwards.
Storage
• Keep the appliance in a dry, dust-free area out of reach of children. Do not place vacuum
cleaner on a rough surface!
• The vacuum cleaner shall be placed on a level surface where there shall be no risk of
tipping over.
• Keep the charging cord in its housing (12) when the appliance is not used.
36