HMN M2 Multi-tip Big Gebrauchsanweisung Seite 29

Periodic errors.
1. The chair won't charge every a empt.
2. The chair will only work periodically, even a er a
reset.
The chair is eleva ng uneven, one defect actuator.
1. If one of the actuators on the chair isn't
eleva ng and the chair is being pulled side-
ways.
HMN a/s
If experiencing periodic errors always try and reset
the chair as described above.
It is also possible that the issue is an incorrectly
mounted wire, so check the wires is plugged correctly
in.
If the problem con nues it might be a defect switch
box. Contact HMN for further advice.
If you o en experience issues with the chair not
working and the resets only work temporarily before
all lights in the hand control are blinking again it
might be sign of incorrectly mounted wires or issues
with the switc box. Contact HMN for further advice.
The actuators on the chair will not always go at the same speed.
This might result in slighty lted seat frame. In this case just lower
the chair completely to reset the pistons in the actuators.
If there is a problem with one actuator not working it might pull
the chair sideways, and this indicates there could be a problem
with that actuator.
Do NOT try to elevate the chair if this is the case.
With this issue we need to know if the frame has been pulled out
of shape. Send us pictures of the frame from the front and back,
and we will be able to tell if the frame is damaged.
If not, just changing the actuator is enough, but if there is damage
to the frame, we might need the chair send to us for repair, or will
send you the needed parts to replace. With these issues always
contact HMN.
HMN
www. dk
.
28